Boot SequenceThis feature allows you to change the boot sequence for devices.Boot Optionsl Hard Drive — The computer attempts to boot from the primary hard drive. If no operating system is on the drive, the computer generates an errormessage.l CD/DVD Drive — The computer attempts to boot from the CD/DVD drive. If no CD/DVD is in the drive, or if the CD/DVD has no operating system, thecomputer generates an error message.l USB Flash Device — Insert the memory device into a USB port and restart the computer. When F12 = Boot Menu appears in the screen, press .The BIOS detects the device and adds the USB flash option to the boot menu.Changing Boot Sequence for the Current BootYou can use this feature to change the current boot sequence, for example, to boot from the CD/DVD drive to run the Dell Diagnostics from the Drivers andUtilities disc. On completion of diagnostic tests, the previous boot sequence is restored.1. If you are booting to a USB device, connect the USB device to a USB connector.2. Turn on (or restart) your computer.3. When F2 = Setup, F12 = Boot Menu appears on the screen, press .If you wait too long and the operating system logo appears, continue to wait until you see the Microsoft® Windows® desktop. Then shut down yourcomputer and try again.The Boot Device Menu appears, listing all available boot devices. Each device has a number next to it.4. On the Boot Device Menu choose the device you want to boot from.For example, if you are booting to a USB memory key, highlight USB Flash Device and press .Changing Boot Sequence for Future Boots1. Enter system setup (see Entering System Setup).2. Use the arrow keys to highlight the Boot Device Configuration menu option and press to access the menu.3. Press the up- and down-arrow keys to move through the list of devices.4. Press plus (+) or minus (–) to change the boot priority of the device.Auto Power On Enables you to set an alarm to turn on the computer automaticallyLow Power Mode Enabled or Disabled (Enabled by default)BIOS Security FeaturesSupervisor Password Status of supervisor installedUser Password Status of user installedSet Supervisor Password Allows to set the desired supervisor passwordExitExit Options Provides options to Load Default, Save and Exit Setup, and Exit Without SavingNOTE: To boot to a USB device, the device must be bootable. To ensure that your device is bootable, check the device documentation.NOTE: To boot to a USB device, the device must be bootable. To ensure your device is bootable, check the device documentation.NOTE: Write down your current boot sequence in case you want to restore it.
