Dell Vostro 220s Service Manual

Also see for Vostro 220 - Vostro 220 Slim Desktop Computer: User guide Setup and features information Setup and quick reference guide System information guide Rack Installation Guide

Contents

Dell Vostro 220s Service Manual Manual pdf 69 page image

Back to Contents PagePower SupplyDell™ Vostro™ 420/220/220s Service ManualRemoving the Power SupplyReplacing the Power SupplyDC Power Supply ConnectorsDC Power Supply Connector Pin AssignmentsCAUTION: Before working inside your computer, read the safety information that shipped with yourcomputer. For additional safety best practices information, see the Regulatory Compliance Homepage atwww.dell.com/regulatory_compliance.CAUTION: To guard against electrical shock, always unplug your computer from the electrical outlet beforeremoving the cover.NOTICE: The procedure for removing and replacing the power supply is identical (except where noted) forthe Vostro 420, Vostro 220, and Vostro 220s computers; the illustrations provided are for example onlyand may not represent your particular computer precisely.Removing the Power Supply1. Follow the procedures in Before Working on Your Computer.2. Remove the computer cover (see Removing the Computer Cover).NOTICE: Note the routing of the DC power cables underneath the metal routing clips (if present) in thecomputer chassis as you remove them from the system board and drives. You must reroute these cablesproperly when you reinstall the power supply to prevent them from being pinched or crimped.3. For the Vostro 220s:a. Remove the chassis support bracket (see Removing the Chassis Support Bracket).b. Slide the optical drive forward far enough to gain access to the PWR1 connector on the system board.c. Remove any installed PCI or PCI Express cards (see Removing a PCI or PCI Express Card).4. Disconnect the DC power cables from the system board (see System Board Components) and the drives.5. Disengage the cables from the routing clips (if present) on the chassis.6. Remove the screws that attach the power supply to the back of the computer chassis.7. Press down on the power supply retention clips.