Replacing the Display Panel | 9713 Align the screw holes on the side I/O-board shield with the screw holes on thechassis and replace the screws that secure the side I/O-board shield to thedisplay bezel.NOTE: Ensure that you also secure the grounding cable with the same screwthat secures the side I/O-board shield to the display bezel.14 Route the power-button, speakers, camera, input source/display-settings controls,wireless keyboard/mouse receiver, and touchscreen cables through their routingguides and connect the cables to the system board.15 Route the wireless-antenna cables through their routing guides and connect theantenna cables to the wireless mini-card.16 Replace the screw that secures the grounding cable to the processorcooling-vents.17 Replace the screw that secures the grounding cable from the right-speaker meshto the middle cover.Postrequisites1 Replace the processor heat-sink fan. See "Replacing the Processor Heat-Sink Fan"on page 52.2 Replace the inner frame. See "Replacing the Inner Frame" on page 50.3 Replace the system-board shield. See "Replacing the System-Board Shield" onpage 32.4 Replace the I/O panel. See "Replacing the I/O Panel" on page 41.5 Replace the stand. See "Replacing the Stand" on page 22.6 Replace the trim cover. See "Replacing the Trim Cover" on page 20.7 Replace the back cover. See "Replacing the Back Cover" on page 18.8 Follow the instructions in "After Working Inside Your Computer" on page 13.
