E t h e r N e t / I P O p e r a t i o n M a n u a l4 - 3 0_4b) Click the Network _0 to check the data mapping status and the error codes. For error codedefinition, refer to section 6.2.4.6 AH Series – Connect to a RTU moduleThis section will provide an overview of how to connect the Delta AH series EtherNet/IP RTU modules suchas AHRTU-ETHN-5A to Delta EIP Scanner and EIP Scanner from other brands. Seet the operation stepsbelow.Op enISPSoftDeltaEIPScannerYOp enEIP Bu ild erNH WC ON FIGSe tup s EIP Bui ld er R TUHWC ON FIG Do wn lo adR TUH WC ON FIG So ftw are…D ow nl oa dt o AH RTUImp ortEDS fi le4.6.1 AHCPU5x1-EN Series/AHCPU560-EN2AHCPU5x1-EN series with firmware version later than V2.00 and AHCPU560-EN2 supports EtherNet/IP.Users can connect to Delta AHRTU-ETHN-5A modules via EtherNet/IP. Once the settings are done, userscan use the devices X, Y and D in AHCPU5x1-EN series and AHCPU560-EN2 to control digital and analogI/O modules connected to AHRTU-ETHN-5A. Running Process:Open EIP Builder and add the module AHRTU-ETHN-5A in the Network View. Open HWCONFIG to set updigital and analog I/O modules of AHRTU-ETHN-5A.
