D E L T A C O M P O N E N T S G m b H Auweg27, D-79761 Waldshut-Tiengen Seite - 56 -4.16 Set PasswordThe User Password utility sets the password. The main board is shipped with the passworddisabled. If you want to change the password, you must first enter the current password, thenat the prompt enter your new password. The password is case sensitive. You can use up toeight alphanumeric characters. Press after entering the password. At the next prompt,confirm the new password by retyping it and pressing again.To disable the password dialog box appears. A message appears confirming that the passwordhas been disabled. If you have set supervisor and user Password, only the supervisor passwordallows you to enter the BIOS setup program.Note: If you forget your password, the only way to solve this problem is to dischargethe CMOS memory by turning power off and placing a shunt (jumper cap)on jumper JP2 to short pin 2 and pin 3 for five seconds, then putting theshunt back to pin 1 and pin 2 of JP2.4.17 Save & Exit SetupSelecting this option and pressing will save the new setting information in the CMOSmemory and continue with the booting process.4.18 Exit Without SavingSelecting this option and pressing will exit the Setup utility without recording anynew values or changing old ones.
