SAVE THESE INSTRUCTIONSINSTALLATION INSTRUCTIONSWARNINGWhen using electrical products, basic precautions should alwaysbe followed, including the following:1. DANGER: RISK OF ELECTRIC SHOCK. Connect only to a circuitprotected by a Ground Fault Circuit Interrupter.2. Grounding is required. The unit should be installed and grounded by aqualified service representative.3. Install to permit access for servicing.IMPORTANT: Follow the instructions EXACTLY and IN THE ORDERLISTED. Once installed, your UV unit will provide years of successfuloperation.TABLE OF CONTENTS0.0 Forward.0 Introduction.0 Pre-Installation. Pond Turnover Rates. Swimming Pool Turnover Rates.0 Desired Flow Rate Chart – Swimming Pools, Fountains, Water Features4.0 Desired Flow Rate Chart – Ponds5.0 Installation5. Locating The UV Unit5. Plumbing The UV Unit – Plumbing Diagram and Bypass Diagram5. Installing Inlet/Outlet Unions5.4 Installing Mounting Legs5.5 Mounting The UV Unit On A Solid Base5.6 Gluing Piping To The UV Unit5.7 Electrical Connection5.8 Electrical Bonding (Grounding)5.9 Electrical Interlock Of Pump/EA Unit6.0 Start-up6. Pump Start-up6. Leak Check Total System6. Swimming Pool Chemical Balance7.0 Maintenance – Quartz Tube Assembly Maintenance/Removal7. Disconnect Power7. Stop Circulation Pump