C h a p t e r 1 2 Tr o u b l e s h o o t i n g1 2 - 8 112.4.10 AH10PFBS-5AError code DescriptionLED indicator statusCPU ModuleBUS FAULT RUN NET16#A4F0 The node address of AH10PFBS-5Aexceeds the valid range. The red light is ON. The greenlight is ON.The greenlight is ON.16#A4F1 Internal hardware error The red light is ON. The greenlight is ON.The greenlight is ON.16#A4F2 Parameter error The red light is ON. The greenlight is ON.The greenlight is ON.16#A4F3 Configuration error The red light is ON. The greenlight is ON.The greenlight is ON.16#A4F4 GPIO detection error The red light is ON. The greenlight is ON.The greenlight is ON.16#A4F5 AH10PFBS-5A enters the mode offactory test. The red light is ON. The greenlight is ON.The greenlight is ON.16#A4F61. AH10PFBS-5A has not beenconnected to the PROFIBUS-DPnetwork.2. PROFIBUS-DP master has notconfigured AH10PFBS-5A slave orthe configured node address ofAH10PFBS-5A is inconsistent withthat of the actually connected one.The red light is ON. The greenlight is ON.The red lightis ON.12.4.11 AH10COPM-5AError code DescriptionLED indicator statusCPU ModuleBUS FAULT ERROR16#A0B0 AH10COPM-5A does not send a heartbeat message aftera set period of time. Blinking The red lightflashes twice.16#A0B1 The length of a PDO that a slave station sends is not thesame as the length of the PDO set in the node list. Blinking OFF16#A0B2 The master station selected does not send a nodeguarding message after a set period of time. Blinking The red lightflashes twice.16#A0E0 AH10COPM-5A receives an emergency message from aslave station. Blinking OFF16#A0E1 The length of a PDO that a slave station sends is not thesame as the length of the PDO set in the node list. Blinking OFF16#A0E2 AH10COPM-5A does not receive a PDO from a slavestation. Blinking OFF16#A0E3 An automatic SDO is not downloaded successfully. Blinking OFF16#A0E4 A PDO parameter is not set successfully. Blinking OFF16#A0E5 A key parameter is set incorrectly. Blinking OFF16#A0E6 The actual network configuration is not the same as thenetwork configuration set. Blinking OFF16#A0E7 The control of the errors in a slave station is not sent aftera set period of time. Blinking The red lightflashes twice.16#A0E8 The master station address is the same as a slave stationaddress. Blinking OFF16#A0F1 No slave station is added to the node list in CANopen Blinking OFF
