ENGLISH12NOTE:• TUNER and V. AUX cannot be selected.• Select “OFF” if nothing is connected.12 OPT2 TV CD AUX DVD TV VCR CDR OFFUse the (left) and (right) buttons to assign the input function connectedto the OPTICAL input 2 (OPT 2) terminal.3(right) button(left) buttonPress the ENTER or (down) button to switch the auto surround modesetting.(Initial)13 AUTOSURR. ON OFF ONFor the three kinds of input signals as shown below, the surround mode played the last is stored in thememory. At next time it the same signal inputs, the memorized surround mode is automatically selected andthe signal is played.Note that the surround mode setting is also stored separately for the different input function.SIGNAL Default Auto Surround Modeq Analog and PCM 2-channel signals STEREOw 2-channel signals of Dolby Digital, DTS or other multichannel format Dolby PLII Cinemae Multichannel signals of Dolby Digital, DTS or other multichannel format Dolby or DTS SurroundSetting the Auto Surround ModeUse the (left) and (right) buttons to select the Auto Surround mode.1(right) button(left) buttonPress the ENTER or (down) button to switch the Ext. In SW Level setting.(Initial)14 EXT.IN SW +15 +00 +05 +10 +15Set the method of playback of the analog input signal connected to the Ext. In terminal.Setting the Ext. In SW LevelUse the (left) and (right) buttons to select the Ext. In Subwoofer channelLevel playback.1(right) button(left) buttonPress the ENTER or (down) button if you want to start the settings overfrom the beginning.(Initial)This completes the system setup operations. Once the system is set up, there is no need to make the settingsagain unless other components or speakers are connected to or the speaker layout is changed.After setting up the systemPress the SYSTEM SETUP button to finish system set up.1• Select “OFF” if nothing is connected.Press the ENTER or (down) button to switch the OPTICAL input 2 (OPT 2)setting.10 COAX CD CD AUX DVD TV VCR CDR OFF11 OPT1 DVD CD AUX DVD TV VCR CDR OFFInput the type of components connected to the digital input terminals.Setting the Digital In AssignmentUse the (left) and (right) buttons to assign the input function connectedto the COAXIAL input (COAXIAL) terminal.1Use the (left) and (right) buttons to assign the input function connectedto the OPTICAL input 1 (OPT 1) terminal.2(right) button(left) buttonPress the ENTER or (down) button to switch the optical input 1 (OPT 1)setting.(right) button(left) button• Select “OFF” if nothing is connected.(Initial)(Initial)