SpecificationsopuiQUICK SELECT[CH SELECT/ENTER]uiopQUICK SELECTuiop[CH SELECT/ENTER][Front][Rear]Button located on both the main unit and the remote controlunitBUTTONButton only on the main unitButton only on the remote control unit[BUTTON]Symbols used to indicate buttons in this manual1Pressor[CH SELECT / ENTER].2Pressui,or[CHSELECT/ENTER]to select “Fader”.3Useopto adjust the volume of the speakers.(o: front,p: rear)• The fader function does not affect the subwoofer.• The fader can be adjusted until the volume of the speaker adjustedto the lowest value is –12 dB.Fader FunctionThis function lets you adjust (fade) the sound from all the front orrear speakers at once.1Pressor[CH SELECT / ENTER].ChannelVolumeFL0.0dBSR0.0dBC0.0dBSBR0.0dBFR0.0dBSBL0.0dBSW0.0dBSL0.0dBFaderFRONT:REAR2Useui,or[CH SELECT / ENTER]to select the speaker.The speaker that can be set switches each time one of thebuttons is pressed.3Useopto adjust the volume.bIn the case of a subwoofer, reducing the volume when it is at “–12dB” will change the setting to “OFF” (none).Channel LevelYou can adjust the channel level either according to the playbacksources or to suit your taste, as described below.Playback1Connect the HDMI to the AVR-1909 with equipmentcompatible with the HDMI control function (vpage62).2Put the power on for all the equipment connected tothe HDMI.3Check the settings for all the equipment connected tothe HDMI and make HDMI available to them.bPleaseconsulttheoperatinginstructionsfortheconnectedequipment to check the settings.bSteps 1~3 do not have to be repeated once started.bCarryout steps 2 and 3 should any of the equipment be pluggedout.4Switch the television input to the HDMI connected tothe AVR-1909.5Switch the AVR-1909 input to the HDMI input sourceand check if the picture from the player is ok.6Put the television power on standby and check if theAVR-1909 goes into standby.If the AVR-1909 does not work please check the following.• Is the menu “Manual Setup” – “HDMI Setup” – “HDMI Control”(vpage 32) set to “ON”?• Is the menu “Manual Setup” – “HDMI Setup” – “Power Off Control”(vpage 32) set to “ON”?• Is the control function used for the television HDMI properly set?(Check the television operating instructions for details.)• Should any of the operations below be performed, the interlockingfunction may be reset, in which case, repeat step’s 2 and 3.•Menu “Input Setup” – “Assign” – “HDMI In” (vpage 42) settinghas changed.•There is a change to the connection between the equipment andthe HDMI, or an increase in equipment.OperationsGetting StartedConnectionsSetupRemote ControlMulti-zoneInformationTroubleshootingENGLISHNOTEWhen the input source is “iPod”, you cannot perform channel levelsetting.NOTEWhen you power off AVR-1909, the HDMI control function does notoperate. Either power on or set to standby.
