271.4. Version display on the Setup MenuUse the following procedure to display the firmware version.(1) Press the "SETUP" button on the remote control.(2) Select "General-Information-Firmware".A version with 20 digits is displayed as shown in the following image.The displayed 20 digits are derived from each device version as shown below.b This firmware version No. (xxxx-xxxx-xxxx-xxxx) is included in the service contact document.These 20 digits are also included in the document.Displays system informationGeneral/FirmwareVersion 1490-0157-0000-1011-2195GUI ImageMainμcom 0 1 1 2 0 0 7 5 Info display 1 4 9 0 - 0 1 5 7 - 0 0 0 0 - 1 0 1 1 - 2 1 9 5DSP 7 3 1 0A.PLD 1 7 0 5GUI 5 9 1 1 0 0 5 9DM860 FBL 0 9 0 3 1 1DM860 SBL B 2 0 1 2 0 1 2 5 0 9 4 1DM860 IMG I 2 0 1 2 0 4 1 0 1 1 0 1The 6th digit from the right for Main μcomThe 5th digit from the right for Main μcomThe 2nd digit from the right for Main μcomThe 1st digit from the right for Main μcomThe 2nd digit from the right for DSPThe 1st digit from the right for DSPThe 1st digit from the right for SBLThe 2nd digit from the right for SBLThe 3rd digit from the right for SBLThe 4th digit from the right for SBLThe 1st digit from the right for IMGThe 3rd digit from the right for IMGThe 4th digit from the right for IMGThe 1st digit from the right for GUIThe 2nd digit from the right for GUIThe shaded partis not used.The 2nd digit from the right for IMGs
