15ENGLISH1 Select the items.The measurement results of each item can be checkedhere.S p C o n f i g . C h e c k* A u t o S e t u pCheck of the measurement results2 Press the ENTER button and display the verificationscreen.[Speaker Config. Check] [Delay Time Check] [Channel Level Check]3 If the check ends, press the ENTER button again.4 Select from the following three items based on themeasurement results.• Store : Set with the checked measurement value.• Retry : Perform the measurement again.• Cancel : Cancel the checked measurement value.S t o r e* A u t o S e t u p5 When the “Store” is selected, all parameters are storedup.When the “Retry” is selected, it measures again.NOTE:• When measurements have been made using the measurement microphone,speakers with a built-in filter such as subwoofers might be set with a value thatdiffers from the physical distance because of the internal electrical delay.(Remote control unit)(Remote control unit)(Remote control unit)(Remote control unit)(Remote control unit)1-2 Setting the Manual EQ SetupAdjust the tone of the various speakers except subwoofer while listening to the sound (music).1 Select “Manual EQ Setup” at the Auto Setup / RoomEQ Menu.M a n u a l E Q S e t u p* A u t o S e t / R o o m E Q2 Display the Manual EQ Setup screen.C h a n n e l : F L* M a n u a l E Q S e t u p3 Select the speaker to be set.The display changes as follows.SBFL FR C SLSRSBLSBR1spkr FlashingWhen the surround back speaker setting is set to“1spkr” at “Speaker Configuration”, this is set to“SB”.C h a n n e l : F L* M a n u a l E Q S e t u p4 Select the frequency.6 3 H z : 0 . 0 d B* M a n u a l E Q S e t u p5 Use the cursor left and right buttons to adjust the Gainlevel.• Each frequency can be adjusted the range from –6 dBto +6 dB in 0.5 dB step.6 Enter the setting.The Auto Setup / Room EQ Menu reappears.(Remote control unit)(Remote control unit)(Remote control unit)(Remote control unit)(Remote control unit)(Remote control unit)