Denon AVR-2805 Operating Instructions Manual

Also see for AVR-3805: Control protocol Service manual Service manual Operating instructions Operating instructions

23ENGLISH3 Select the component (Y, P B/C B and P R/C R) video input terminal to be assigned to the input source.q Select the source selection. w Select the component video input terminal.Select “NONE” for sources for which thecomponent (Y, P B /CB and P R /CR ) videoinput is not to be used.When the default, “Yes”, is selected,the settings are reset to the factorydefaults.4 Enter the setting.The Input Setup Menu reappears.3-4 Setting the Video Input Mode1 Select “Video Input Mode” at the Input Setup Menu.V i d e o I n M o d e* I n p u t S e t u p2 Display the Video Input Mode screen.D V D : A u t o* V i d e o I n M o d e3 q Select the input source forwhich you want to set the VideoInput Mode.w Select the mode as below.AUTO COMPONENT Svideo VideoThe details in each mode are as follows.AUTO: When there are multiple input signals, the input signals are detected and the input signalto be output from the video monitor output terminal is selected automatically in thefollowing order: component video, S-Video, composite video.Component: The signal connected to the component video terminal is always played.Video conversion is not conducted, so no image is output from the monitor output terminalwhen there is no input signal to the component terminal.S-Video: The signal connected to the S-Video terminal is always played.The S-Video input signal is converted and output from the composite and componentmonitor output terminal.Video: The signal connected to the composite video terminal is always played.The composite video input signal is up-converted and output from the S-Video andcomponent monitor output terminals.NOTE:Down-converting from the component video signal to the S-Video and composite video signal is notpossible, so when not using the component video monitor output terminal connect the player using theS-Video or composite video input terminal.Cautions on the video conversion function:When the component video terminals are used to connect the AVR-2805 with a TV (or monitor, projector,etc.) and the video (yellow) or S video terminals are used to connect the AVR-2805 with a VTR, dependingon the combination of the TV and VTR the picture may flicker in the horizontal direction, be distorted, beout of sync or not display at all when playing video tapes.If this happens, connect a commercially available video stabilizer, etc., with a TBC (time base corrector)function between the AVR-2805 and the VTR, or if your VTR has a TBC function, turn it on.4 Enter the setting.The Input Setup Menu reappears.3-3 Setting the Component In Assign• This setting assigns the color difference (component) video input jacks of the AVR-2805 for the different inputsources.1 Select “Component In Assign” at the Input SetupMenu.C o m p o n e n t I n* I n p u t S e t u p2 Display the Component In Assign screen.D V D : V 1* C o m p o n e n t I n(Remote control unit)(Remote control unit)(Remote control unit)(Remote control unit)(Remote control unit)(Remote control unit)(Remote control unit)(Remote control unit) (Remote control unit)(Remote control unit)