Denon AVR-390 Owner's Manual

Also see for AVR-390: Service manual

Denon AVR-390 Owner's Manual Manual pdf 30 page image

Getting Started Connections Setup Information TroubleshootingENGLISHSpecificationsiPod® PlaybackThe music on an iPod can be played by using the control dockfor iPod (ASD-1R, ASD-11R, ASD-3N or ASD-3W, sold separately).The operation can also be performed using the buttons on theremote control unit.iPod is a trademark of Apple Inc., registered in the U.S.and other countries.b The iPod may only be used to copy or play contents that are notcopyrighted or contents for which copying or playback is legallypermitted for your private use as an individual. Be sure to complywith applicable copyright legislation.1 Make the necessary preparations.q Set the iPod in the DENON control dock for iPod.(vSee the control dock for iPod’s operating instructions.)w Assign the control dock for iPod’s input.The input for the control dock for iPod is assigned to VCR bydefault.“iPod Assign” – “Assign” (vpage 16)2 Press or [VCR (iPod)] to select theinput source assigned in step 1-w above.3 Press [SEARCH] and hold it down for a 2 seconds ormore to select the display mode.To switch between modes, press and hold down the button.When remote mode is active, “REMOTE” is displayed.[Display mode] Browse mode Remote modeDisplay location Main unit display iPod displayPlayablefilesAudio file S SVideo file Sz1 Sz2ActivebuttonsRemotecontrol unit(AVR-390)S SiPod A Sz1 : When using an ASD-3N or ASD-3W control dock for iPod.z2 : Video may not be output, depending on the combination ofASD-1R or ASD-11R and iPod.Preparations• With the default settings, the iPod can be used connected to theVCR (iPod) connector.• Press or [POWER OFF] and set the AVR-390’s powerto the standby mode before disconnecting the iPod. Also switch theinput source to one to which “iPod Assign” is not assigned beforedisconnecting the iPod.• When using an ASD-3N or ASD-3W control dock for iPod, refer tothe respective manual to operate.• When you wish to output iPod video to a monitor, connect theS-Video output of the control dock for iPod to the S-Video inputterminal (DVD or VCR) of AVR-390.Listening to Audio1 Use [ui] to select the item, then press [ENTER] or[p] to select the music file to be played.2 Press [ENTER] or [p].Playback starts.Button located on both the main unit and the remotecontrol unit BUTTONButton only on the main unit