Denon AVR-5803 Operating Instructions Manual

Also see for AV Surround Receiver AVR-5803: Setup guide Reference guide Specifications Operating instructions Service manual

Contents

Denon AVR-5803 Operating Instructions Manual Manual pdf 20 page image

20Setting the type of speakers• The composition of the signals output from the different channels and the frequency response are adjusted automatically according to thecombination of speakers actually being used.2 At the System Setup Menu select “Speaker Configuration”.3 Switch to the speaker configuration screen.4 Set whether or not speakers areconnected and, if so, their sizeparameters.• To select the speaker• To select the parameter Center Sp.Front Sp.SubwooferSurround Sp. ASurround back Sp.Surround Sp. B1 Press “CURSOR/PAGE” at the center of the bottom line on the “AV AMP’s” “SETTING 3/5” page sothat this part is displayed in half-tone dot mesh.Make the system setups by pushing the jog stick on the remote control unit forward and backward, leftand right.5 Enter the setting.a) If no surround speakers are used (if “None” is set for both A and B):The Crossover Frequency screen appears.b) If both surround speakers A and B are used (if either “Large” or “Small” is set for both A and B):The surround speaker setting screen appears.c) When “Front” is set to “Large” and “Subwoofer” is set to “Yes”, the set switches to the subwoofer mode.d) If “None” is set for surround speakers A:“None” is automatically set for surround speakers B and surround back speaker.NOTE:• Select “Large” or “Small” not according to the actual size of the speaker but according to the speaker’s capacity for playing low frequency(bass sound below frequency set for the Crossover Frequency mode and below) signals. If you do not know, try comparing the sound at bothsettings (setting the volume to a level low enough so as not to damage the speakers) to determine the proper setting.