Denon AVR-787 Operating Instructions Manual

Also see for AVR-787: Service manual Service manual Specifications Dimensions

Contents

Denon AVR-787 Operating Instructions Manual Manual pdf 15 page image

MeasuresCauseExampleq This screen will be displayed when the speakers requiredfor producing suitable reproduction have not been detected.• Check that the pertinent speakers are properly connected.w This screen will be displayed when the speaker polarity isconnected in reverse.• Check the polarity of the pertinent speakers. For somespeakers, this screen may be displayed even though thespeakers are properly connected.If so, select “Skip0”.e This screen will be displayed when accurate measurementscannot be made due to the input level of the microphone beingtoo high.• Set up the speakers so that their position is farther awayfrom the listening position.• Lower the volume of the subwoofer speaker.Easy Setup Procedure Easy Setup Procedure12ENGLISHENGLISHError messages• These error screens may be displayed when performing Auto Setup measurement and the automatic measurements can not be completedbecause of the speaker arrangement, measurement environment, or other factors. Please check the following matters, reset the pertinentitems, and measure again.• When there is too much noise in the room, the speakers may not be detected properly. Should this happen, perform the measurements whenthe noise level is low, or switch off the power of the equipment that is producing the noise for the duration of the measurements.Press DD HH to select the items, then press FF.r This screen will be displayed when the measurementmicrophone is not connected.• Connect the measurement microphone to the microphoneconnector.u Checking and storing the measurementresultsPress DD HH to select an item, then press ENTER.The measurement results of each item can be checked here.1After checking, press ENTER, then press DD HH to set.2When “Store” is selected:Press ENTER.31 2• When measurements have been made using the measurementmicrophone, speakers with a built-in filter such as subwoofers mightbe set with a value that differs from the physical distance becauseof the internal electrical delay.Retry:Perform the measurement again.Measurement is repeated.Store:All the settings are stored in the memory.Cancel:Cancel the auto setup settings.