Denon AVR-990 Owner's Manual

Also see for AVR-990: Specification Before Upgrading Guide Getting started Service manual Service manual

Contents

Denon AVR-990 Owner's Manual Manual pdf 51 page image

Getting Started Connections Remote ControlZONE2 Information Troubleshooting SpecificationsENGLISHMaking the Input Settings (Input Setup)Setting contents–12dB ~ +12dB (0dB)The analog input level and digital input level can be adjusted independently for input sources forwhich “HDMI” or “Digital” is assigned at “Input Assign“ (vpage 45).Corrects the playback level of the selected input source’s audio input.Set this if there are differences in the input volume levels between the different sources.••Correcting the Input Source’s Playback Level(Source Level) Default settings are underlined.Setting items Setting contentsRenameChange the display name ofthe selected input source.1. Press p or ENTER.2. Use o p to set the cursor to the character you want to change.3. Use ui to change the character, then press ENTER.Up to 8 characters can be input.The input character type can be switched by pressing [SEARCH] whilethe display name is being changed.The types of characters that can be input are as shown below.•••GUpper case charactersH ABCDEFGHIJKLMNOPQRSTUVWXYZGLower case charactersH abcdefghijklmnopqrstuvwxyzGSymbolsH ! “ # $ % & ’ ( ) * + , - . / : ; < = > ? @ [ \ ] ˆ _ ` { | } ˜(Space)GNumbersH 01234567894. Repeat steps 2 and 3 to change the display name.DefaultReset all settings to factorydefault.Yes : Reset to the defaults.No : Do not reset to the defaults.If you select “Default” and press ENTER the message “DefaultSetting?” is displayed. Select “Yes” or “No”, and then press ENTER.Changing the Input Source’s Display Name (Rename)Setting items Setting contentsInput ModeSet the audio input modes forthe different input sources.Auto : Automatically detect input signal and perform playback.HDMI : Play only signals from HDMI input.Digital : Play only signals from digital input.Analog : Play only signals from analog input.EXT. IN : Play only signals from EXT. IN input.“HDMI” can be set for input sources for which “HDMI” is assigned at“Input Assign”.“Digital” can be set for input sources for which “Digital” is assigned at“Input Assign”.When digital signals are properly input, the ” ” indicator lights onthe display. If the ” ” indicator does not light, check the digital inputconnector assignment and the connections.The surround mode cannot be set if the input mode is set to “EXT. IN”.This can also be set by pressing [INPUT MODE]. Each time you press thebutton, the input mode display will change.•••••Auto HDMI DigitalAnalogEXT. INDecode ModeSet the decode mode forinput source.This can be set when the input source is CD DVD HDP TVSAT/CBL VCR DVR V.AUX .Auto : Detect type of digital input signal and decode and playautomatically.PCM : Decode and play only PCM input signals.DTS : Decode and play only DTS input signals.This can be set for input sources for which “HDMI” or “Digital” isassigned at “Input Assign” (vpage 45).Normally set this to “Auto”. Set “PCM” and “DTS” when inputting thecorresponding input signal.••The selectable input modes depend on the input source and “Input Assign” (vpage 44) setting.Changing the Input Mode and Decoding Mode(Input Mode) Default settings are underlined.Remote control operationbuttons:Displaying the menuCancel the menu:Moves the cursor(Up/Down/Left/Right) :Confirm the setting :Return to previous menuPlaybackSettings