Denon AVR-990 Owner's Manual

Also see for AVR-990: Specification Before Upgrading Guide Getting started Service manual Service manual

Contents

Denon AVR-990 Owner's Manual Manual pdf 79 page image

Getting Started Connections Settings Remote ControlZONE2 Information Troubleshooting SpecificationsENGLISHWhen you make an HDMI connection with a TV or player compatiblewith AVR-990 and HDMI control functions, you can perform thefollowing operations by setting the HDMI control function of eachdevice.When you want to listen to TV audio by AVR-990, connect opticaldigital or analog audio (vpage 14 “Connecting the Monitor”).When using these functions set as follows: “HDMI Control”(vpage 35) set to “ON”.••NOTEWhen “HDMI Control” is set to “ON”, it consumes more standbypower.The HDMI control function controls operations of a TV that iscompatible with the HDMI control function. Make sure that the TVand HDMI are connected when you perform HDMI control.When you power off AVR-990, the HDMI control function does notoperate. Either power on or set to standby.Some functions may not operate depending on the connected TVor player. Check the owner’s manual of each device for detailsbeforehand.When “HDMI Control” is set to “ON”, it is not possible to assign anHDMI terminal to “TV” at “Input Assign” (vpage 45).•••••1 Turn the power on for all the equipment connectedby HDMI cable.2 Set the HDMI control function for all equipmentconnected by HDMI cable.Set “HDMI Control” (vpage 35) to “ON“.Please consult the operating instructions for the connectedequipment to check the settings.Carryout steps 1 and 2 should any of the equipment be pluggedout.bb3 Switch the television input to the HDMI connected tothe AVR-990.4 Switch the AVR-990 input to the HDMI input sourceand check if the picture from the player is ok.5 When you turn the TV’s power to standby, checkthat the power of the AVR-990 and player also goeson standby.If the HDMI control function does not operate properly, check thefollowing points.Is the TV or player compatible with the HDMI control function?Is the AVR-990 properly set?Is the “HDMI Control” (vpage 35) set to “ON”?Is the “Power Off Control” (vpage 35) set to “ON”?Are the HDMI control function settings of all equipment correct?•••••NOTEShould any of the operations below be performed, the interlockingfunction may be reset, in which case, repeat step’s 1 and 2.“Input Assign” – “HDMI” (vpage 45) setting has changed.There is a change to the connection between the equipment and theHDMI, or an increase in equipment.••AVR-990 power off can be linked to the TV poweroff step.When you set “Output audio from amp” in the TV audio outputsetup operation, you can switch the amp power on.You can switch audio output devices with a TVoperation.You can adjust AVR-990 volume in the TV volumeadjustment operation.You can switch AVR-990 input source through linkageto TV input switching.When playing the player, the AVR-990 input functionswitches to the function of that player.nnnnnHDMI Control FunctionConvenient FunctionsPlayback