149Resetting the microprocessorPerform this procedure if the display is abnormal or if operations cannot be performed.Note that when the microprocessor is reset, all the settings are reset to their default values.XSOURCE SELECT 1SOURCE SELECT 01 Turn off the power using X.2 Press X while simultaneously pressing SOURCE SELECT 0 and SOURCE SELECT1.3 Once the display starts flashing at intervals of about 1 second, release the twobuttons.If in step 3 the display does not flash at intervals of about 1 second, start over from step 1.Specificationsn Audio section• Power amplifierRated output: Front:90 W + 90 W (8 Ω/ohms, 20 Hz – 20 kHz with 0.08 % T.H.D.)125 W + 125 W (6 Ω/ohms, 1 kHz with 0.7 % T.H.D.)Center:90 W (8 Ω/ohms, 20 Hz – 20 kHz with 0.08 % T.H.D.)125 W (6 Ω/ohms, 1 kHz with 0.7 % T.H.D.)Surround:90 W + 90 W (8 Ω/ohms, 20 Hz – 20 kHz with 0.08 % T.H.D.)125 W + 125 W (6 Ω/ohms, 1 kHz with 0.7 % T.H.D.)Surround back:90 W + 90 W (8 Ω/ohms, 20 Hz – 20 kHz with 0.08 % T.H.D.)125 W + 125 W (6 Ω/ohms, 1 kHz with 0.7 % T.H.D.)Output connectors: 6 – 16 Ω/ohms• AnalogInput sensitivity/Input impedance: 200 mV/47 kΩ/kohmsFrequency response: 10 Hz – 100 kHz — +1, –3 dB (DIRECT mode)S/N: 100 dB (IHF–A weighted, DIRECT mode)n Tuner section [FM] [AM](Note: μV at 75 Ω/ohms, 0 dBf = 1 x 10–15 W)Receiving Range: 87.5 MHz – 107.9 MHz 520 kHz – 1710 kHzUsable Sensitivity: 1.2 μV (12.8 dBf) 18 μV50 dB Quieting Sensitivity: MONO 2.8 μV (20.2 dBf)S/N : MONO 70 dB (IHF–A weighted, DIRECT mode)STEREO 67 dB (IHF–A weighted, DIRECT mode)Total harmonic Distortion: MONO 0.7 % (1 kHz)STEREO 1.0 % (1 kHz)n GeneralPower supply: AC 120 V, 60 HzPower consumption: 460 WPower consumption in standby mode: 0.1 WPower consumption in CEC standbymode: 0.5 WPower consumption in networkstandby mode: 2.7 WFor purposes of improvement, specifications and design are subject to change without notice.