Denon AVR-X4500H Owner's Manual

Also see for AVR-X4500H: Service manual Owner's manual

Connecting speakersHere we connect the speakers in the room to this unit.Before connecting speakersNOTE0 Disconnect this unit’s power plug from the power outlet before connecting thespeakers. Also, turn off the subwoofer.0 Connect so that the speaker cable core wires do not protrude from the speakerterminal. The protection circuit may be activated if the core wires touch the rearpanel or if the + and - sides touch each other. (“Protection circuit” (v p. 321))0 Never touch the speaker terminals while the power cord is connected. Doing socould result in electric shock. When the “Setup Assistant” (page 9 in the separate“Quick Start Guide”) is running, follow the instructions in the “Setup Assistant”screen for making connections. (Power is not supplied to the speaker terminalswhile the “Setup Assistant” is running.)0 Use speakers with an impedance of 4 – 16 Ω/ohms.NOTE0 Carry out the following settings when using a speaker with an impedance of 4 – 6Ω/ohms.1. Press and hold the main unit’s STATUS and ZONE3 SOURCE at the sametime for at least 3 seconds.“zVideo Format ” appears on the display.2. Use u or i on the main unit three times.“zSp. Impedance <8ohms>” appears on the display.3. Use o or p on the main unit to select the impedance.8ohms(Default):Select when the impedance for all of theconnected speakers is 8 Ω/ohms or over.6ohms: Select when the impedance for any of theconnected speakers is 6 Ω/ohms.4ohms: Select when the impedance for any of theconnected speakers is 4 Ω/ohms.4. Press the main unit’s ENTER to complete the setting.Contents Connections Playback Settings Tips Appendix40Front panel Display Rear panel Remote Index