Denon AVR-X500 Owner's Manual

Also see for AVR-X500: Service manual Getting started Owner's manual

Contents

59AppendixTipsPlaybackConnectionsContentsFront panel Display Rear panel IndexRemoteSettingsCrossoversSet in accordance with the lower limit frequency of the base frequenciesthat can be played back through each speaker.2 Set the crossover frequency40Hz / 60Hz / 80Hz (Default) / 90Hz / 100Hz / 110Hz / 120Hz / 150Hz /200Hz / 250Hz%• “Crossovers” can be set when the “SW Mode” (vpage 59) setting is“LFE+Main”, or when you have a speaker that is set to “Small”.• The default crossover frequency is “80Hz”, which will work best with thewidest variety of speakers. We recommend setting to a higher frequency thatthe crossover frequency when small speakers are used. For example, set to“250Hz” when the frequency range of the speakers is 250 Hz – 20 kHz.• For speakers set to “Small”, low frequency content below the crossoverfrequency is attenuated to the speakers and the low bass content is thenre-delivered to the subwoofer, or the front (L/R) speakers if they have beenset to Large.BassSet subwoofer and LFE signal range playback.2 LPF for LFESet LFE signal playback range. Set this when you want to change theplayback frequency (low pass filter point) of the subwoofer.80Hz / 90Hz / 100Hz / 110Hz / 120Hz (Default) / 150Hz / 200Hz / 250Hz2 SW ModeSelect low range signals to be reproduced by subwoofer.LFE : The low range signal of the channel set to “Small” speaker size isadded to the LFE signal output from the subwoofer.LFE+Main (Default) : The low range signal of all channels is added tothe LFE signal output from the subwoofer. This isusually the best setting for most systems.%• “SW Mode” can be set when “Speaker Config.” – “Subwoofer”(vpage 57) is set to other than “No”.• Play music or a movie source and select the mode offering the strongestbass.• If “Front” and “Center” for “Speaker Config.” (vpage 57) are set to“Large”, and “SW Mode” is set to “LFE”, no sound may be output from thesubwoofers, depending on the input signal or selected surround mode. Select“LFE+Main” if you want the bass signals to always be produced from thesubwoofer.