74AppendixSettingsPlaybackConnectionsContentsFront panel Display Rear panel IndexRemoteTipsTroubleshootingIf a problem should arise, first check the following:1. Are the connections correct?2. Is the set being operated as described in the owner’s manual?3. Are the other devices operating properly?If this unit does not operate properly, check the items listed in the table below. Should the problem persist, there may be a malfunction.In this case, disconnect the power immediately and contact your store of purchase.2 Power does not turn on / Power is turned offSymptom Cause / Solution PagePower does not turn on. • Check whether the power plug is correctly inserted into the power outlet. 33Power automatically turns off. • The sleep timer is set. Turn on the power again.• “Auto Standby” is set. “Auto Standby” is triggered when there is no operation for a setamount of time. To disable “Auto Standby”, set “Auto Standby” on the menu to “Off”.4961Power turns off and the powerindicator flashes in red approx. every2 seconds.• The protection circuit has been activated due to a rise in temperature within this unit. Turn thepower off, wait about an hour until this unit cools down sufficiently, and then turn the poweron again.• Please re-install this unit in a place having good ventilation.89–Power turns off and the powerindicator flashes in red approx. every0.5 seconds.• Check the speaker connection. The protection circuit may have been activated becausespeaker cable core wires came in contact with each other or a core wire was disconnectedfrom the connector and came in contact with the rear panel of this unit. After unplugging thepower cord, take corrective action such as firmly re-twisting the core wire or taking care of theconnector, and then reconnect the wire.• Turn down the volume and turn on the power again.• This unit’s amplifier circuit has failed. Unplug the power cord and contact our customerservice center.1935, 36–