AudysseySet Audyssey MultEQ® XT32, Audyssey Dynamic EQ®, AudysseyDynamic Volume® and Audyssey LFC™. These can be selected afterAudyssey® Setup has been performed.For additional information on Audyssey technology, please see“Explanation of terms” (v p. 350).0 “MultEQ® XT32”, “Dynamic EQ”, “Reference Level Offset”, “Dynamic Volume”,“Audyssey LFC™”, “Containment Amount” and “Audyssey DSX®” settings arestored for each input source.0 When the sound mode is in the “Direct” or “Pure Direct” mode, “MultEQ® XT32”,“Dynamic EQ” and “Dynamic Volume” settings cannot be configured.0 This cannot be set when the input mode is set to “7.1CH IN”.o MultEQ® XT32MultEQ® XT32 compensates for both time and frequencycharacteristics of the listening area based on Audyssey® Setupmeasurement results. Selection is done from three types ofcompensation curves. It is recommended that “Reference” is selected.Reference(Default):Selects the default calibrated setting witha slight roll off at high frequencies, whichis optimized for movies.L/R Bypass:Selects the reference setting, butbypasses MultEQ® XT32 on the front leftand right speakers.Flat:Selects the calibrated setting which isoptimized for small rooms where yourlistening position is closer to thespeakers.Off : Turn “MultEQ® XT32” equalizer off.When the headphones are used, “MultEQ® XT32” is automatically set to “Off”.Contents Connections Playback Settings Tips Appendix199Front panel Display Rear panel Remote Index
