NetworkTo use this unit by connecting it to a home network (LAN), you must configure network settings.If you set up your home network (LAN) via DHCP, set “DHCP” to “On”. (Use the default setting.) This allows this unit to use your home network (LAN).When assigning an IP address to each device manually, you need to assign an IP address to this unit using the “IP Address” settings, and enterinformation about your home network (LAN) such as the gateway address and subnet mask, etc.InformationDisplay network information.Friendly Name / Connection / SSID / DHCP / IP Address / MACAddressMAC Address is required to create a vTuner account.ConnectionChoose whether to connect the home network to a wireless LAN or awired LAN.When connecting to the network using wired LAN, select “Wired(Ethernet)” after connecting a LAN cable,When connecting to the network using wireless LAN, select “Wireless (Wi-Fi)” and configure the “Wi-Fi Setup”.o Connect UsingSelect the method for connecting to the home network (LAN).Wired (Ethernet): Use a LAN cable to connect to a network.Wireless (Wi-Fi): Use the wireless LAN (Wi-Fi) function to connectto a network.You can disable the Wi-Fi function of this unit by configuring the followingsettings.1. Press and hold the main unit’s o and p at the same time for at least 3seconds.“zVideo Format ” appears on the display.2. Use the main unit’s i to display “zWired LAN ”.3. Use the main unit’s o or p to select “”.4. Press the main unit’s ENTER to complete the setting.Contents Connections Playback Settings Tips Appendix271Front panel Display Rear panel Remote Index
