Denon DBP-A100 Owner's Manual

Also see for DBP-A100: Owner's manual Owner's manual

Contents

ENGLISH7TroubleshootingInformationHDMI Control FunctionPlaybackSetupConnections SpecificationsInserting the BatteriesAbout the Remote Controle Put the rear cover back on.q Remove the rear cover. w Set three R6/AA batteries inthe battery compartment in theindicated direction.NOTE• Use R6/AA batteries in this remote control.• Replace the batteries with new ones if the set does not operateeven when the remote control is operated close to the unit. (Thesupplied batteries are only for verifying operation.)• Be sure to insert the batteries in the proper direction, following the“q” and “w” marks in the battery compartment.• To prevent damage or leakage of battery fluid:Do not use a new battery with an old one.Do not use two different types of batteries.Do not attempt to charge dry batteries.Do not short-circuit, disassemble, heat or dispose of batteriesin a fire.• If the battery fluid leaks, carefully wipe the fluid off the inside of thebattery compartment and insert new batteries.• Remove the batteries from the remote control if it will not be usedfor a long time.• Used batteries should be disposed of in accordance with localregulations on battery disposal.Operating Range of the Remote ControlOperate the remote control while pointing it at the remote sensor.30°30°Approx.23feet/7mNOTEThe set may function improperly or the remote control may notoperate if the remote control sensor is exposed to direct sunlight,strong artificial light from an inverter type fluorescent lamp or infraredlight.Remote Control Settings (RemoteControl Side)Switches when the DBP-A100’s remote control operates anotherDENON BD players in the vicinity.Set the remote control code simultaneously on the main unit, too.For instructions on setting codes, see GUI menu: “Other Setup” –“Remote Control Setting” – “Remote ID” (vpage 31).GRemote control code settingH1 : Set the remote control code to “1”.2 : Set the remote control code to “2”.• If the signal code of the remote control does not match the signalcode of the unit, the remote control code set on the unit is shownon the display.GExampleHIf the code setting on the unit is “DENON 1”, and the setting on theremote control is “2”, “PLAYER 1” is shown on the display.NOTE• Match the signal code of the remote control with the signal code ofthe unit. If the remote control code is different, you cannot operatethe DBP-A100 with the remote control.• Even if you change the remote control code, set the GUI menu“Other Setup” – “Remote Control setting” – “Receive LegacyRemocon” (vpage 31) to “Off” when operating the DBP-A100with a remote control other than DENON’s.Getting Started