Denon DCD-485 Operating Instructions Manual

Also see for DCD-485: Service manual Service manual

Contents

7ENGLISH!6 Dimmer Button (DISPLAY)• Push this button to change the brightness of the display.• Push once to make the display 2/3 as bright as normal.• Push again to make the display 1/3 as bright as normal.• Push once again to turn the entire display off during playbackand all except the track number off in any other mode.!7 Stop Button (2 STOP)• Push this button to stop playback or pause mode.The disc will stop rotating.!8 Random Button (RANDOM)• Push this button to play the track in random order.(Refer to page 11.)!9 Play Button (1 PLAY)• Push this button to start playback of a disc during stop orpause mode.• When this button is pushed, is displayed and thetrack number being played is displayed.• Tracks are shown on the calendar display. Once a track hasbeen played, the corresponding track number goes out onthe calendar display.@0 Pause Button (3 PAUSE)• Push this button to stop playback temporarily duringplayback.• When this button is pushed during playback, playback isstopped temporarily, the indicator goes out and theindicator lights.• Push this button or the 1 PLAY button again to continueplayback.@1 Open/Close Button (5 OPEN/CLOSE)• The disc holder is opened and closed by pushing this button.• Push this button once to open the disc holder and once againto close it.• When the disc holder is closed with a disc loaded, the discwill rotate for a few seconds while the disc contents areread. The number of tracks and total playback time on thedisc are then displayed on the digital display t.@2 Disc Holder• Place the disc on the disc holder with the label facing up.• Use the 5 OPEN/CLOSE button @1 to open and close thedisc holder.• The disc holder may also be closed by pressing the 1 PLAYbutton !9 or 3 PAUSE button @0.@3 Digital Output Jack (OPTICAL)• Digital data is output in optical form from this jack.(Refer to page 7 for connections.)@4 Output Terminal (LINE OUT)• Connect these jacks to the input jacks on your amplifier.(Refer to page 7 for details on the connections.)@5 AC INLET• Connect the included AC cord here.3 PAUSE1 PLAY1 PLAYCONNECTION(1) Connecting the Output Terminal (LINE OUT)Use the included pin cords to connect the left (L) and right (R)output terminal (LINE OUT) of the DCD-485/685 to the CD, AUXor TAPE PLAY left (L) and right (R) input jacks of the amplifier.Connection Precautions• Before proceeding with connections or disconnections of cablesand power cords, be sure to turn all system components off.• Ensure that all cables are connected properly to the L (left) and R(right) jacks.• Insert plugs fully into the terminals.• Connect the output jacks to the amplifier CD, AUX or TAPE PLAYinput jacks.DCD-485/685AC INLINE OUTDIGITAL OUTOPTICAL R LAmplifierPower supply outlet(2) Connecting the Digital Output Jack (OPTICAL)Use an optical link cable to connect the digital output jack(OPTICAL) of the DCD-485/685 to the digital input jack (OPTICAL)on a digital processor or CD recorder, available in stores.DCD-485/685AC INLINE OUTDIGITAL OUTOPTICAL R LDigital processor or CD recorderPower supply outlet