Denon DHT-FS3 Owner's Manual

Also see for DHT-FS3: Specifications Owner's manual

Contents

ENGLISHTroubleshootingIf a problem should arise, first check the following:1. Are the connections correct ?2. Is the set being operated as described in the operating instructions ?3. Are the other components operating properly ?If this unit does not operate properly, check the items listed in the table below. Should the problem persist, there may be a malfunction.In this case, disconnect the power immediately and contact your store of purchase.Symptom Cause Measures PageWhen the power is turned on, thepower indicator does not light andno sound is produced.• The power supply cord’s plug is not fully pluggedin.• Check the insertion of the power supply cord plugand connect securely.9The power indicator lights but nosound is produced.• The speaker cables are not properly connected.• The function (input) is incorrect.• The volume is turned all the way down.• The mute mode is set.• Analog connection cables are not securelyconnected.• No digital signal is being input.• Connect securely.• Switch to the correct function (input).• Press the VOL+ button on the main unit or theVOLUME button on the remote control unit.• Cancel the mute mode.• Connect securely.• Properly select a digital signal input source.71212, 15128, 912No DTS sound isproduced. • DVD player’s audio output setting isn’t set to bitstream.• DVD player is not DTS-compatible.• DHT-FS3’s input setting is set to analog.• Use the DVD player’s default settings.• Use a DTS-compatible player.• Use a digital input and set the surround mode to“SURR”.–––No sound is produced fromsubwoofer.• Subwoofer’s output is not connected. • Connect securely. 7Remote control unit does notoperate.• The batteries are flat.• The remote control unit is too far away.• There is an obstacle between the main unit andthe remote control unit.• The batteries are inserted in the wrong direction.• Replace with new batteries.• Operate from closer to the main unit.• Remove the obstacle.• Insert the batteries in the proper direction.2222Setting the punch through function1 Set [MODE SELECTOR] to the component to beregistered (DHT).2 Press [TV VOL +] and [MENU / GUIDE] at the sametime.• The indicator starts flashing.3 Input the number of the component you want to set.• By default “DVD” is set.No.TV SAT/CABLE DVD [MENU / GUIDE][TV VOL +][MODE SELECTOR]With the punch through function, the TV, SAT/CABLE and DVDoperations can be performed even when the [MODE SELECTOR] is setto the “DHT” position.TroubleshootingGetting Started Installation Connections Settings Operation Other functions Operating theremote control unit SpecificationsENGLISH