Stereo mini-plug cable6ConnectionsCable indicationsConnect using the connection cables shown below.Analog connections (Stereo)ARLRLPin-plug cable(White)(Red)Audio signalOUT INAnalog connections (Monaural, for subwoofer)BPin-plug cableSpeaker connectionsESpeaker cableSystem connectionsFSystem cableRecommended system layoutTo ensure performance and safety, it is recommended to arrange the components as shown below whenconnecting to models in the F102 series.DCD-F102orCHR-F103DRA-F102DABDRR-F102NOTE:• Arrange in such a way that the receiver’s ventilation holes are not obstructed so that the heat candissipate.• Do not place other components directly on top of the receiver.• To ensure safety, do not make stacks of more than three components.Audio cableIN OUTGetting StartedDigital terminal (Optical)DOptical fiber cableAnalog connections (Stereo)CSignal directionNOTE:• Do not plug in the power supply cord until all connections have been completed.• When making connections, also refer to the operating instructions of the other components.• Be sure to connect the left and right channels properly (left with left, right with right).• Do not bundle power supply cords together with speaker cables. Doing so could result in hummingor noise.• Making connections with the power turned on could result in noise or damage the speakers.• Bunching the power supply cords and connection cables together could result in humming or noise.• Connect all the connection cables between the different components firmly. The system may notoperate properly if the connections are incomplete.• Be sure to disconnect the power supply cords when changing the connections. Changing theconnections while the system is operating could result in malfunction.• Plug the power cords of devices that are used connected to the DRA-F102 DAB into the DRA-F102DAB’s AC outlets. Do not use the outlets for hairdryers or other non-audio devices.• Do not turn up the volume when no turntable is connected to the PHONO input terminals. Doing sowill cause humming or noise.When not connecting a turntable, leave the included short-circuiting pin plug plugged in.