Denon DRR-M33 Operating Instructions Manual

Also see for DRR-M33: Operating instructions

Contents

(option)5ENGLISH4 CONNECTIONS 1234Connect the DRR-M33’s SYSTEM CONNECTOR terminalto the SYSTEM CONNECTOR terminal on the CD receiver(RCD-M33/M35DAB) using the included system cord.Connect this unit’s power supply cord to the AC outlet onthe CD receiver (RCD-M33/M35DAB) .Connect the DRR-M33’s LINE OUT terminals to the CDreceiver’s TAPE IN terminals using the included stereoaudio cord.Connect the DRR-M33’s LINE IN terminals to the CDreceiver’s TAPE OUT terminals using the included stereoaudio cord.NOTES:• Do not plug power supply cords into power outlets until allconnections have been completed.• Check the left and right channels and be sure tointerconnect them correctly (R to R, L to L).• Plug in the power supply cords securely.Incomplete connections will result in noise.• Clasping the power supply cords and connection cordstogether may result in humming or noise.• After unplugging the power supply cord, wait at least 5seconds before plugging it back in.✽ The DRR-M33 can also be used when connected to areceiver other than the RCD-M33/M35DAB. In this case,none of the system functions (auto power on, etc.) will work.✽ Some receivers other than the RCD-M33/M35DAB areequipped for connections of two or more cassette deck’s,allowing tapes to be copied. Read your receiver’s operatinginstructions carefully before using it.Connecting to the RCD-M33/M35DAB2 When connecting to a receiver other than the onein the RCD-M33/M35DAB there is no need to makeconnection 3. Note that in this case none of thesystem functions (auto power on, etc.) will work.• System operations such as the auto power onfunction can only be used if stereo audio cords andsystem cords are connected between all thesystem components. Be sure to securely connectall the connection cords between all the units.• Disconnecting a system cord during systemoperation may result in malfunction. Be sure tounplug the power supply cords before changing theconnections.• Install the components in such a way that theventilation holes of the CD receiver (RCD-M33/M35DAB) are not obstructed.• Use the AC OUTLET for audio equipment only.Do not use them for hair driers, etc. Recommended System Installation• Do not place another component directly on top of the CDreceiver (RCD-M33/M35DAB).• To ensure stability, do not stack more than two units.1234Power plugAC 230 V, 50 Hz(Plug into a power outlet)Cassette deck(DRR-M33)Power plug(for U.K. model)CD receiver (RCD-M33/M35DAB)RCD-M33/M35DABDRR-M33RCD-M33/M35DABDRR-M33Install the sets as shown in one of thesediagrams. In either case, be sure that the CDreceiver’s ventilation holes are not obstructed.[Side by side installation][Stacking installation]✽ The illustration of the CD receiver in the diagram or the operation description is for the RCD-M33/M35DAB.