7070DVD-5900/DVD-A11Pin DescriptionsInput PinsPin Name Pin # Type DescriptionD23-D12 See PinDiagramIn Upper 12 bits of 24-bit pixel bus. Mode controlled by configuration register bit:When BSEL = HIGH, this bus inputs the top half of the 24-bit pixel bus.When BSEL = LOW, these bits are not used to input pixel data.D11–D0 See PinDiagramIn Bottom half of 24-bit pixel bus / 12-bit pixel bus input. Mode controlled byconfiguration register bit:When BSEL = HIGH, this bus inputs the bottom half of the 24-bit pixel bus.When BSEL = LOW, this bus inputs ½ a pixel (12-bits) at every latch edge (bothfalling and/or rising) of the clock.IDCK+ 57 In Input Data Clock +. This clock is used for all input modes.IDCK- 56 In Input Data Clock –. This clock is only used in 12-bit mode when dual edgeclocking is turned off (DSEL = LOW). It is used to provide the ODD latching edgesfor multi-phased clocking. If (BSEL = HIGH) or (DSEL = HIGH) this pin is unusedand should be tied to GND.DE 2 In Data enable. This signal is high when input pixel data is valid to the transmitterand low otherwise.HSYNC 4 In Horizontal Sync input control signal.VSYNC 5 In Vertical Sync input control signal.Input Voltage Reference PinPin Name Pin # Type DescriptionVREF 3 AnalogInMust be tied to 3.3V.Power Management PinPin Name Pin # Type DescriptionPD# 10 In Power Down (active LOW). A HIGH level (3.3V) indicates normal operation and aLOW level (GND) indicates power down mode.www. xiaoyu163. comQQ 376315150 992894298TEL 13942296513 992894298051513673QQTEL 13942296513 QQ 376315150 892498299TEL 13942296513 QQ 376315150 892498299http://www.xiaoyu163.comhttp://www.xiaoyu163.com