Connecting to a WPS NetworkSolution Refer to PageIf your wireless router support WPS (Wi-Fi Protected Setup™) your HEOS Wireless Speaker can optionally connect to yournetwork using the “Push Button” method by following these steps:1. Press the WPS button on your router.2. Within 2 minutes, Press and Hold the Connect button on the rear panel of the HEOS speaker for 5 seconds.3. The LED on the front of the speaker will flash green for several seconds as it connects to your WPS router.4. When the connection is complete, the LED on the front of the speaker will turn solid blue.6Resetting Your SpeakerSolution Refer to PageResetting your speaker will clear out the wireless network info, EQ, and name but retain it’s current software. You will have to useSettings - Add Speaker to reconnect the speaker to your home network before it can be used.To reset your speaker, gently insert a small paperclip into the Reset button hole on the back of the speaker and hold it in until thefront LED begins to flash amber.–Contents Setup Use Troubleshooting Status LED Appendix51
