Distorted sound from the HEOS HomeCinemaSolution Refer to Page0 If the signal source is a volume-controlled output, turn it down a couple of steps from maximum. －0 Check the signal source to be sure the distortion is not originating there. －0 If HEOS HomeCinema’s volume is set to its maximum, turn it down a few steps. －Trouble teaching HEOS HomeCinema remote control commandsSolution Refer to PageRemember that while HEOS HomeCinema can learn almost all IR (infrared) remote commands, there remain a few rare codeformats that cannot be taught (much like some engineers we know).–Television speakers keep getting turned back upSolution Refer to PageDisable the television’s speakers (usually a setup-menu option, but a rear-panel switch on some televisions). If this is not possible,the problem is likely that the television responds to press-and-hold (ramping) volume commands more quickly than the HEOSHomeCinema; in this rare case use HEOS HomeCinema’s front-panel or supplied remote to turn the HEOS HomeCinema’svolume up.–Contents Setup Use Troubleshooting Status LED Appendix53
