Denon PMA-710AE Owner's Manual

Also see for PMA-710AE: Service manual User manual

Contents

Connections Operation TroubleshootingENGLISH SpecificationsFor buttons not explained here, see the page indicated in parentheses ( ).q Power indicatorChanges as shown below according to PMA-710AE’s status.• For several seconds after the power is turnedon ··············································· Red (blinking)• Power “ON” ············································Green• Muting ······································· Red (blinking)• Standby······················································ Red• Power “OFF” ··············································· Offw Power switch(hON/STANDBY jOFF )When set to “hON/STANDBY”, the power turnson, and when set to “jOFF”, the power turnsoff.e Headphones jack (PHONES)r BASS control knobt TREBLE control knoby BALANCE control knobu VOLUME control knobi REC OUT SELECTOR knobo INPUT SELECTOR knobUse this to select the source that you wish tolisten to.Q0 Input indicatorThe selected input is shown with an orangeindicator.Front Panelq w e r t y iu oQ0Q1Q2Q4 Q3Part Names and FunctionsQ1 SOURCE DIRECT switchWhen set to “hON”, the signals do not passthrough the tone adjustment circuitry (bass,treble, balance and loudness), resulting inplayback with higher sound quality.When set to “jOFF”, the sound can beadjusted to your tastes.Q2 LOUDNESS switchWhen listening with the volume turned low, setthis to “hON” to amplify the bass and treblesound that is hard to hear when the volume islow and achieve a more natural sound.Q3 SPEAKERS A/B switches• When A (or B) is set to “hON”, sound isproduced from the speakers connected to theA (or B) speaker output terminals.• When both A and B are set to “hON”, sound isproduced from the speakers connected to boththe A and B speaker output terminals.• When both A and B are set to “jOFF”, nosound is produced from the speakers. Use thiswhen listening over headphones.Q4 Remote control sensorRear Panelq w e r tyuq Input terminals (INPUTS)Connect your source equipment here.w Recording input/output terminals(RECORDER-1 and RECORDER-2)Connect your recording equipment here.e PRE OUT terminalsUse this to add such equipment as a poweramplifier or subwoofer.r Speaker system terminals(SPEAKER SYSTEMS)Connect your speakers here.t AC OUTLETSUse this as the power outlets for other audiodevices. Check equipment power requirementratings before use (see the ratings as markedon the rear panel). If in doubt consult with yourdealer or DENON distributor.y Power cordu SIGNAL GND (ground) terminalConnect the ground wire from your turntablehere.NOTE• This terminal is not a safety ground.• NEVER insert the short-circuiting pin plug intothe recording output or PRE OUT terminals.Doing so could result in damage.NOTEFunctions r, t, y and Q2 are only available whenthe SOURCE DIRECT switch is set to “jOFF”.• When the VOLUME control knob is set justbeyond the “12 o’clock” position (over halfway),the adjustments that can be made with the BASSand TREBLE controls is decreased.• When the VOLUME control knob is set tomaximum or turned fully clockwise, the base andtreble can no longer be adjusted.Getting Started