265. CD heat run mode(1) Plug AC cord into power outlet while pressing "2" and "+ / 9" button same time on Main Unit. (Be sure to insertthe CD before this operation)1 3C D 1 1 Tr 4 2 : 5 2(1, 3 lit / Normal display except when 1, 3 lit.)(2) Switches to mode according to button input. See No.5.1 and No.5.2.(3) If an error occurs, display the error and stop operation at that point. Number of operations held. See No.5.3 toNo.5.5.(4) Heat run no. cleared when "2" button pressed.(5) Mode canceled and tray opened after "5" button pressed.(6) Press the "Power operation (X)" button to clear this mode too.5.1 Normal heat run mode• After CD heat run mode has started, re-read TOC and press the "1/3" button. (Be sure to finish reading the TOCbefore push "1/3" button) Count this as the 0th heat run repetition.q Play from the first to last track on disc.w If disc being used has less than 20 tracks, play all tracks. If disc has 21 or more tracks, skip to final track afterplayback of first track has finished.e After disc playback has finished, move pickup to innermost position and open tray.The heat run repetition no. isincremented (increased by 1) when the tray is opened.r When loader open status detected, close tray again, re-read TOC and start playback from the first track on thedisc.t Conduct q to r repeatedly.【During playback is display】1 3C D 0 1 Tr 0 1 : 4 7(1, 3 lit / Normal display except when 1, 3 lit.)【Number of heat run is display (No.5.1 e)】1 3C D X X X X(1, 3 lit / XXXX:No. of heat run repetitions)5.2 Automatic mounting mode(1) After CD heat run mode has started, re-read TOC and press the "2" buton once in the stop mode.(2) TOC reading ⇒ Search for first track on disc ⇒ tray open ⇒ tray close ⇒ TOC reading ⇒ repeat. No. heat runrepetitions displayed on time display section.(3) Increment the heat run repetition no. at the point when the loader has finished opening.【When the tray is open】1 3C D X X X X(1, 3 lit / XXXX:No. of heat run repetitions)【When the tray is closed】1 3C L O S E(1, 3 lit)