6ENGLISHProtection circuitThe protection circuit is be activated in the following situations:• If the speaker cable wire touches the rear panel or screws or if thespeaker cable wire touches the speaker cable’s + and – sides aretouching• If the surrounding temperature is extremely high• If the inside of the amplifier gets hot to extended use at a highoutputIf this happens, unplug the power cord, then check the connectionsof the speaker cables and input cables. If the unit becomes very hot,wait for it to cool off and improve the ventilation around it. After doingthis, plug the power cord back in.If the protection circuit is activated even though there are no problemswith the ventilation around the unit or in connections, the unit maybe damaged. Turn off the power and then contact a DENON servicecenter.Connecting recording componentsCD recorder / MD recorderCables used for connectionsAudio cable (sold separately)Stereopin-plug cable RLRL(White)(Red)COAX.75ǡLOOPANT.ETHERNETNETWORKFMAMANTENNATUNERLRAUX OUT AUX IN 1 AUX IN 2PREOUTSUBWOOFER AUX IN 3(OPTICAL)ARCD-N7W3- 3-*/ 065"6%*0"6%*0RLRLRLRLCD recorder /MD recorder /Tape deckConnecting a TV• Select the connector to use and connect the device.• To listen to TV audio through this device, use the optical digitalconnection.Cables used for connectionsAudio cable (sold separately)Stereopin-plug cable RLRL(White)(Red)Optical cableCOAX.75ǡLOOPANT.FMAMANTENNATUNERAUX IN 2 AUX IN 3(OPTICAL)3-065"6%*0"6%*0RLRL015*$"-065TVNOTEOther digital audio signals than 2 channel linear PCM cannot be inputthrough AUX IN 3 (OPTICAL) terminal of this unit.When you try to input digital audio signals other than 2 channel linearPCM to this unit, set the digital audio output setting of the TV to 2channel PCM.For details, see the operating instructions of the TV.Speaker connections