7Getting Started ConnectionsConnections Basic Operations Advanced Operations TroubleshootingExplanation termsInformation Specifi cations IndexENGLISHConnecting an antennaFM/AM• Connect the FM antenna or AM loop antenna supplied with the unitto enjoy listening to radio broadcasts.• After connecting the antenna and receiving a broadcast signal(vpage 16 “Tuning in Broadcast Stations”), fix the antenna withtape in a position where the noise level becomes minimal.COAX.75ǡLOOPANT.ETHERNETNETWORKFMAMANTENNATUNERLRAUX OUT AUX IN 1 AUX IN 2TFER AUX IN 3(OPTICAL)RCD-N7Ww eqAM loop antenna(Supplied)FM indoor antenna(Supplied)WhiteBlackNOTE• Do not connect two FM antennas simultaneously.• Even if an external AM antenna is used, do not disconnect the AMloop antenna.• Make sure the AM loop antenna lead terminals do not touch metalparts of the panel.• If the signal has noise interference, connect the ground terminal(GND) to reduce noise.• If you are unable to receive a good broadcast signal, we recommendinstalling an outdoor antenna. For details, inquire at the retail storewhere you purchased the unit.n AM loop antenna assembly1 Put the stand sectionthrough the bottom ofthe loop antenna fromthe rear and bend itforward.LoopantennaStandSquareholeProjectingpart2 Insert the projecting partinto the square hole inthe stand.n Using the AM loop antennaSuspending on a wallSuspend directly on a wall without assembling.Nail, tack, etc.Standing aloneUse the procedure shown upper to assemble.