Getting Started Connections Setup Remote Control Information TroubleshootingENGLISH<+/–><1 3>[ENTER][FM/AM][TUNING +/–][CHANNEL +/–][uio p] [ENTER][AUDIO/RDS][NUMBER][CALL][MEMO][SUBTITLE/PTY][ANGLE/CT][ZOOM/RT][uio p]About the button names in these explanations< > : Buttons on the main unit[ ] : Buttons on the remote control unitButton name only:Buttons on the main unit and remote control unitListening to Radio BroadcastsTuning in Broadcast Stations1 Pressor[FM/AM]toselect“TUNER”.2 Use or [FM/AM] to select the receptionband.FM MONO AMFM AUTO3 Use <+/–>, [TUNING +/–] or [o p] to select thereceptionfrequency.When a station is received, the “TUNED” indication will light.A humming sound may be heard when using a TV nearby whilereceiving AM programs. If this happens, move the system as far fromthe TV as possible.Display of the FM broadcast reception status• When the reception band mode is set to “FM AUTO” and a stereobroadcast is tuned in, the “ST” indicator lights.• If the signal is weak and stable stereo reception is not possible, setthe reception band mode to “FM MONO” and receive the programin monaural. The “MONO” indicator lights.Main unit <+/–> buttonThere are two, switchable modes fo <+/–> the tuning mode for settingthe reception frequency (setting upon purchase), and the preset modefor selecting the preset broadcast station.n Switching the preset modePressing <+> while pressing in .“PRESET” is flashes for approximately 5 seconds.n Switching the tuning modePressing <–> while pressing in .“TUNING” is flashes for approximately 5 seconds.Auto tuningWhen [TUNING +/–] or [o p] is pressed and held in, the set automaticallystarts searching for a broadcast station.b Stations whose signal is weak cannot be tuned in.To stop the auto tuningPress [TUNING +/–] or [o p].Manual tuningThe reception frequency changes each time [TUNING +/–] or [o p] ispressed.Naming the Currently Tuned in BroadcastStation and Presetting itUp to 60 stations (total for AM and FM) can be preset.Names of up to 8 characters can be input.1 Tuneinthebroadcaststation2 Press[MEMO] twice.The name input mode is set.3 Use [ui] to select the character, then press[ENTER].b Characters that can be input.A to Z, 0 to 9 + [CALL] for small letters! “ # $ % & ’ ( ) * + , – . / : ; < = > ? @ [ \ ] ˆ _ { ¦ } (space)b Press [op] to move the cursor.Use this to correct input characters.b To cancel character input, press [MEMO].Everything that has been input is canceled.4 Onceyouarefinishedinputting,press[ENTER].“P0 –” flashes on the preset number display.5 Use[ui]toselectthenumber,thenpress[ENTER].Oruse[NUMBER](0~9,+10)toselectthenumber.The preset number, reception band and reception frequency aredisplayed, then the name of the broadcast station appears.Changing the broadcast station nameq Call out the preset name you want to change, then press [MEMO]twice.wPerform steps 3 and 4 at “Naming the currently tuned in broadcaststation and presetting it”.Playback
