Getting Started Getting Started3ENGLISHENGLISHCautions on loading discs• Only load one disc at a time. Loading two or more discs can damagethe set or scratch the discs.• Do not use cracked or warped discs or discs that have been repairedwith adhesive, etc.• Do not use discs on which the sticky part of cellophane tape orlabels is exposed or on which there are traces of where labels havebeen removed. Such discs could get caught inside the player anddamage it.About discsDiscs usable on this setq Music CDsDiscs with the mark at the right can be used onthis set.Note however that discs with special shapes(heart-shaped discs, octagonal discs, etc.) cannotbe played. Do not attempt to play them, as doingso could damage the set.w CD-R/CD-RW• Some discs and some recording formats may not be playable.• Non-finalized discs cannot be played.Finalization:Finalization is the process that makes recorded CD-R/CD-RW discsplayable on compatible players.Holding discsDo not touch the signal surface.Loading discs• Set the disc with the labeled side facing up.• Make sure the disc tray is fully open when inserting the disc.• Place the discs flatly, 12 cm discs in the outer tray guide (Figure 1),8 cm discs in the inner tray guide (Figure 2).Figure 1Outer tray guide12 cm discsFigure 2Inner tray guide8 cm discs• Place 8 cm discs in the inner tray guide without using an adapter.• In the following cases, “00 Tr 00 : 00” is shown on the display:• When no disc is loaded• When the disc is loaded upside-down• When the disc’s information could not be read properlySpeaker system (SC-S81)When installing the speakers, pay attention to the points describedbelow.• Note that placing the speaker system on the same stand or shelf asa record player may result in howling.• If a magnet or a piece of furniture or equipment using magnets isplaced near the speakers, note that interaction with the S-81 couldcause color blotching on the TV.• The speakers can also be placed sideways.Set the speaker sideways and fasten the stand securely to thespeaker using the two screws that previously fastened the stand.Grasp the two edges of the saran net with your fingers and pulltowards you to remove the net, then press on the back of the badgeand turn the badge to set it sideways.• The speakers can also be installed using the included wallmount brackets.Use the four included short screws to securely fasten the wallmount bracket to the mount screw holes on the back of the speaker.SC-S81SC-S81ScrewsScrewsSpeaker standWall bracketCAUTION:• Mount on a wall sufficiently sturdy to bear the weight of thespeaker. Note that DENON will except no responsibilitywhatsoever for damages or accidents caused by the speakerfalling.• To ensure safety, have a specialist install the speakers on thewall.• Be sure to fasten the speaker connection cables to the wall, etc.,so that you do not get your feet or hands caught in them, causingthe set to fall.