Denon UD-M31 Operating Instructions Manual

Also see for UD-M31: Specification sheet Operating instructions Service manual

Contents

11ENGLISHLISTENING TO RADIO PROGRAMSUse this to automatically search for FM broadcasts and store up to 40 stations at preset channels 1 to 40.Auto tuner presetsON / STANDBYCD RECEIVER UD-M31TONE/SDBFUNCTIONMENU / SETBANDPHONESVOLUME+-132 54NOTE:• If an FM station cannot be preset automatically due to poor reception, use the “Manual tuning” operation to tunein the station, then preset it using the manual “Preset memory” operation.(Check the connections on Pages 6.)1 Press the power operation switch to turn on thepower.ON / STANDBY2 Press the FUNCTION button to select TUNERmode.4Press the MENU/SET button for at least 2 seconds.• “A PRESET”, “CANCEL –” and “START +”appear alternately on the UD-M31’s display.• Press the – button to cancel.FUNCTION+5Use the + button to select “START”.• “SEARCH” flashes on the display and searchingbegins.• The TUNER function display reappears oncesearching is completed.• If you want to stop searching, press the – button.MENU / SET9 Manual tuningON / STANDBYCD RECEIVER UD-M31TONE/SDBFUNCTIONMENU / SETBANDPHONESVOLUME+-3 41 2NOTE:• A humming sound may be heard when using a TV nearby while receiving AM programs. If this happens, move thesystem as far from the TV as possible.Example: Tuning in FM 92.50 MHz(AM stations are tuned in using the same procedure.)1 Press the power operation switch to turn on thepower.ON / STANDBY2 Press the FUNCTION button to select TUNERmode.3 Press the BAND button on the tuner to select theFM AUTO.FUNCTION+-4Use the Tuning +/– button to tune the frequency to92.50. Once the frequency is tuned in, adjust thevolume to the desired level using the VOLUMEcontrol.BAND✽ This lights when a station is tuned in.✽ The function of the +/– button on the main unit may toggle between Tuning +/– and Preset +/– functions.• Pressing the – button while holding down the BAND button at the same time changes function of the +/– button toTuning +/–. (“TUNING” flashes for 5 seconds.)• Pressing the + button while holding down the BAND button at the same time changes the function of the +/– buttonto Preset +/–. (“PRESET” flashes for 5 seconds.)• The +/– button is factory preset to function as a Tuning +/– button.However, be sure that the +/- buttons function as the Tuning +/– button before proceeding with step 4.Auto Tuning• When a program being broadcast in stereo is received, the “ST” indicator lights and the program is received in stereo.• If reception is poor and there is much noise in the stereo signals, press the BAND button to set the FM MONO mode.• When one of the Tuning +/– button is pressed, the frequency changes in steps of 100 kHz in the FM band, 10 kHz inthe AM band.• If one of the Tuning +/– button is held for over 1 second, the frequency continues to change when the button isreleased (auto tuning) and stops when a station is tuned in. Tuning will not stop at stations whose reception is poor.• To stop the auto tuning function, press the Tuning +/– button once.3 Press the BAND button to select the FM AUTO orthe FM MONO.BAND