186D.2 Interface CablesWith the interface cables described in this section, DENSO WAVE has run the qualityassurance test conforming to the EMC Directive for the BHT-100Q/100B series and CU-7001.Any connectors other than those specified here are not acceptable. They may causethe BHT or CU to fail to work according to the specifications.For BHTCable 1Wind the cable on a ferrite core twice and then secure the core with a heat-shrinkabletube.➀ Connector P161 Teisin Electric Co., Ltd.➁ D-sub connector D -F-T-N series (EMI-durable) Japan AviationElectronics Industry Ltd.➂ Connector cover 17JE series hood/cable clamp DDK Ltd.(shielded)➃ Cable Super flex VVC 7/0.18 mm x 3C Bando Densen Co., Ltd.➄ Ferrite core ZCAT2035-0930A TDK Corporation➅ Heat-shrinkable tubeNote: A square ( ) in the above specifications denotes a numeral that will varyaccording to the number of connector pins.