Denso BHT-1700 Series User Manual

Also see for BHT-1700 Series: Hardware user manual

Contents

Denso BHT-1700 Series User Manual Manual pdf 23 page image

- 12 -3.5.4. Error CodeWhen an error occurs during the system update, an error dialogue is displayed.If any error is not cleared even if the following actions are taken, check the error code and consult with the systemadministrator.Code Description Action100110022056The battery level is insufficient. Please charge the battery to 50% or more withthe charging cradle and start updating.1010 A package file does not exist. Check that a correct package exists in the BHT.If it exists, a package file inside the BHT may bedamaged.When an SD card is used, the SD card may bedamaged.In this case, place the package file in the internalstorage correctly, and then retry.1011 An extension of a package file is notcorrect.1044 Failure to read the package1021 SD card has not been inserted. Check that an SD card has been inserted.When an SD card is not used, select setting inthe menu button and check" Use internal storage".10401051Storage data capacity is insufficient. Secure the sufficient data capacity for update andretry.Twice as large data capacity as that of thepackage file is required as a target.1080 Not applicable BHT is used. The currently used BHT (model) is not used forthe specified system package.Place the correct system package file to the BHTand retry.1041109520222030204020722082The status of an application requiredfor the update is incorrect.A required application may not be correctlyinstalled in the BHT.Execute the following in turn.- Reboot the BHT, and then retry.- Reset to the factory default, and then retry.(Refer to 3.6 Resetting to the Factory Default(FactoryReset) and Enterprise reset .)3040 Updating by person other than anownerOnly owners can carry out the system update.When the multi user mode is used, switch theuser to the owner, and then retry.E001 The system update service has notbeen installed.Required applications may not be correctlyinstalled in the terminal.Execute the following in turn.- Reboot the BHT, and then retry.- Reset to the factory default, and then retry.(Refer to 3.6 Resetting to the Factory Default(FactoryReset) and Enterprise reset .)E002 The old version of the system updateservice is used.E003 The old version of the system updateapplication is used.E004 The system update service does notrespond.E005 The system update service hasalready been in operation.If the update has already been in operation fromanother application, wait until it is completed.If this code is indicated even though the system isnot updated, reboot the BHT, and then retry.E006 The previous update result does notexistThis code is indicated when the update result isconfirmed even though the system has neverbeen updated.If this code is indicated after the update, rebootthe BHT, and then retry.XXXX Errors other than the above(Including the case when an errordialogue is not displayed)Execute the following in turn.- Reboot the BHT, and then retry.- Insert or remove a BHT battery, and then retry.- Reset to the factory default, and then retry.(Refer to 3.6 Resetting to the Factory Default(FactoryReset) and Enterprise reset .)