DentalEZ RAM VAC Osprey User Manual
                                         | |
Contents
| 
www.DentalEZ.com 866-DTE-INFO12Osprey TMCompressorPN: 1045DOC_E4. Adjust each foot to approximately the sameheight, then thread a flanged nut (flange sidetoward the leg) onto each foot (Figure 5).NOTE: It is not necessary to tighten the flanged nutsat this time. The feet will require further adjustmentonce the compressor has been placed in itspermanent location in the utility room.5. Lift the compressor and remove the blockingfrom under the tank end. Repeat steps2 through 4 for the opposite end of thecompressor.6. After the compressor is in its permanent locationin the utility room, adjust each foot using a 7/16"wrench until the compressor is setting level.After adjusting the feet, tighten the flanged nutwith a 1/2" wrench to lock the foot into position.Section III InstallationFigure 5. Install flanged nutFeet Kit (Continued)WARNING• Prior to starting this assembly, read,understand and follow the safetyinformation and the assembly instructionsin this user manual.• The bowl on the coalescing filter assemblyis under high pressure while the systemis running. Allow the compressor to stoprunning and release the air from the un-loader valve prior to removing the bowl.Failure to allow the system to properly de-pressurize could result in severe injuries.• Always disconnect the compressorfrom the electrical power source prior toconducting any maintenance or serviceof the equipment. The compressor couldstart unexpectedly, resulting in possibleinjury to the service technician.• This procedure may not comply with allsafety requirements of federal, state orlocal agencies or safety requirements ofthe installer’s employer. If a confl ict doesexist, follow the requirements set forth bythe other organizations.Parts Included• Drain Hose• Elbow FittingElbowFitting Drain HoseFigure 6. Filter drain kit partsFilter Drain Kit |
Related manuals for DentalEZ RAM VAC COSP22S
manualsdatabase
Your AI-powered manual search engine