Denver Instrument P-114 Operation Manual
Also see for P-114: Operating instructions
                                              | |
Contents
| 
Counting ModeIn counting mode, you can determine the number of parts, eachhaving approximately the same weight. A reference weight isdetermined for the reference quantity and the balance weighs andcounts similar pieces.The balance will display both the piece count and the combinedweight in units set as the primary units.Pressing the TARE key will exit from any menu without sav-ing changes.The total sample weight must not exceed the balancecapacity.The weight of each piece must be greater than the resolu-tion of the balance.Entering count mode:1. Press MENU.2. When “Applications” is highlighted, press the .3. Press until “Count Mode” is highlighted, then press the .4. Using the and selected the desired reference quantity (5,10, 20, 50 or 100 or custom).5. Press the ENTER key to accept and begin count mode.Memo:Note:5102050100CustomNormal ModeCount ModeCheck WeighAnimal ModeTarget WeighStatisticsFormulation12Memo:Note:Memo:Note: |
manualsdatabase
Your AI-powered manual search engine