www.desatech.comTRIM KITINSTALLATION INSTRUCTIONSIncludes Hardware Kit 102865-01Installation InstructionsNote: Firebox model may vary from that shown in Figure 2.1. Remove packaging from three pieces of trim.2. Locate the two adjusting plates with set screws and two shimsin the hardware packet.If any of these pieces are missing or damaged, contact the dealerwhere you purchased this kit or DESA at 1-866-672-6040 forreferral information. You can also visit DESAʼs technical serviceweb site at www.desatech.com.3. Align shim under adjusting plate as shown in Figure 1.4. Slide one end of adjusting plate/shim in slot on mitered edgeof top trim (see Figure 1).5. Slide other end of adjusting plate/shim in slot on mitered edgeof side trim (see Figure 1).Figure 2 - Attaching Trim to FireboxSide TrimMitered EdgeShimAdjustingPlateSet Screws Top TrimSlotSlotAssembledTrimTrim HangingShoulder ScrewLocationsHanging Notcheson TrimFigure 1 - Assembling Trim6. While firmly holding edges of trim together, tighten both screwson the adjusting plate using a slotted screwdriver.7. Repeat steps 2 through 6 for other side.8. Place the assembled trim onto firebox cabinet. Align hangingnotches on trim with trim hanging shoulder screws (see Figure 2).Tap trim firmly into place with palm of hand or rubber malletby engaging hanging notches around shoulder screws. Start atone end of the trim and work around firebox until all notchesare fully engaged.