Parts included with this kit:Part No. Description QuantityInstruction Sheet 1105798-04 Pilot Orifice, Propane/LP 1105523-02 Burner, Propane/LP 1104506-04 Main Burner Orifice (1.39mm) 1105799-02 Gas Valve Regulator 1105801-02 Conversion Label, English 1106038-02 Conversion Label, French 1106080-01 Conversion Information Label 1Tools Required• 10mm Open End Wrench • 3/8" Socket, Nut Driver or• 5/16" Socket or Nut Driver Slotted Screwdriver• 18mm Open End Wrench or • #2 Phillips ScrewdriverAdjustable Wrench • 7/16" Open End Wrench• 3/4" Open End Wrench or • Needle Nose PliersAdjustable Wrench • High Temperature Silicone Sealant• 7/8" Open End Wrench or (GE RTV 106/Loctite RTV 81585)Channel Lock Pliers • Thread Sealant (Resistant to Propane/LP)If any of these pieces are missing or damaged, contact the dealer where you purchased thiskit or DESA International at 1-800-972-7879 for referral information.INSTALLATION INSTRUCTIONSFOR PC-BVBN (02285)CONVERSION KITNATURAL GAS TO PROPANE/LP GASFor Use When Converting Models SBVBN(A) or CBVBN(A)INTERNATIONALThis conversion kit must be installed by a qualified service agency.Read these instructions completely before installing this conversion kit.Before proceeding, make sure the gas control valve is in the “OFF” position, all electricalpower to the appliance is OFF, and the fireplace is cool to the touch.CAUTION: The gas supply shall be shut off prior to disconnecting theelectrical power before proceeding with the conversion.REMOVING GLASS DOORThe glass door must be removed to allowaccess inside the firebox chamber for con-version. To remove the glass door, the frontpanel on the stove body must be removed.1. To remove the stove front panel, re-move two 10mm hex bolts from bot-tom of stove and one phillips head boltfrom top of stove (see Figure 1).2. Using a 3/8" socket or slotted screw-driver remove the screws from the twotabs at the top of the glass door (seeFigure 2, page 2). Hold glass door se-curely to keep it from falling forward.3. Grasp door by both sides and ease itupward off the lower bracket (see Fig-ure 2, page 2).Bolt (PhillipsHead)Figure 1 - Removing Stove Front PanelBolt (10mm Hex)Stove Front PanelNote: Appearance ofStove Body may varydepending on Model