Desa DCFTNA Owner's Operation And Installation Manual

Also see for CDCFNR: OWNER'S OPERATION AND INSTALLATION MANUAL OWNER'S OPERATION AND INSTALLATION MANUAL Owner's operation

Contents

www.desatech.com 111244-01E24OPERATING FIREPLACEContinuedNote: It is safe to operate fireplace with blowerturned off. However, the blower helps distributeheated air from the fireplace.Figure 43 - AUTO/OFF/ON Blower SwitchAUTO/OFF/ON SwitchREMOTE-READY MODELSFOR YOUR SAFETYREAD BEFORE LIGHTINGWARNING: If you do not fol-low these instructions exactly,a fire or explosion may resultcausing property damage, per-sonal injury or loss of life.A. This appliance has a pilot which must belighted by hand. When lighting the pilot,follow these instructions exactly.B. BEFORE LIGHTING smell all around theappliance area for gas. Be sure to smell nextto the floor because some gas is heavier thanair and will settle on the floor.WHAT TO DO IF YOU SMELL GAS• Do not try to light any appliance.• Do not touch any electric switch; do notuse any phone in your building.• Immediately call your gas supplier froma neighborʼs phone. Follow the gassupplierʼs instructions.• If you cannot reach your gas supplier, callthe fire department.C. Use only your hand to push in or turn thegas control knob. Never use tools. If theknob will not push in or turn by hand, donʼttry to repair it, call a qualified service tech-nician or gas supplier. Force or attemptedrepair may result in a fire or explosion.D. Do not use this appliance if any part has beenunder water. Immediately call a qualified ser-vice technician to inspect the appliance and toreplace any part of the control system and anygas control which has been under water.LIGHTINGINSTRUCTIONSWARNING: You must operatethis fireplace with the screen inplace. Make sure fireplace screen isinstalled before running fireplace.NOTICE: During initial opera-tion of new fireplace, burninglogs will give off a paper-burn-ing smell. Open window to ventsmell. Operate fireplace on HIposition to burn off odor. Thiswill only last a few hours.WARNING: Burner will comeon automatically within one min-ute when control valve is in the ONposition after the pilot is lit.1. STOP! Read the safety information startingin column 1.2. Make sure equipment shutoff valve is fullyopen.3. Press in and turn control knob clockwiseto the OFF position (see Figure 44).4. Wait five (5) minutes to clear out any gas.Then smell for gas, including near the floor.If you smell gas, STOP! Follow “B” in thesafety information, column 1. If you donʼtsmell gas, go to the next step.5. Press in and turn control knob counter-clockwise to the PILOT position.Press in control knob for five (5) seconds(see Figure 44).Note: You may be running this fireplace forthe first time after hooking up to gas sup-ply. If so, the control knob may need to bepressed in for 30 seconds or more. This willallow air to bleed from the gas system.Figure 44 - Control Knob and IgnitorButton Location (Shown as Supplied- No Control Options)HILOINOUTPiezoIgnitorButtonControlKnobFlameAdjustmentKnob