Desa DCFTNA Owner's Operation And Installation Manual

Also see for CDCFNR: OWNER'S OPERATION AND INSTALLATION MANUAL OWNER'S OPERATION AND INSTALLATION MANUAL Owner's operation

Contents

www.desatech.com111244-01E 25OPERATING FIREPLACEContinued6. With control knob pressed in, press andrelease ignitor button. This will light pilot.The pilot is attached to the front burner. Ifneeded, keep pressing ignitor button untilpilot lights.Note: If pilot does not stay lit, contact aqualified service person or gas supplier forrepairs. Until repairs are made, light pilotwith match. To light pilot with match, seeManual Lighting Procedure.7. Keep control knob pressed in for 30 secondsafter lighting pilot. After 30 seconds, releasecontrol knob.• If control knob does not pop out whenreleased, contact a qualified service personor gas supplier for repairs.Note: If pilot goes out, repeat steps 4through 8.8. Slightly push in and turn control knob coun-terclockwise to the ON position.9. Set flame adjustment knob to any levelbetween HI and LO.CAUTION: Do not try to ad-just heating levels by using theequipment shutoff valve.Figure 45 - Propane/LP Gas PilotIgnitorElectrodePilotBurnerFigure 46 - Natural Gas PilotIgnitorElectrodePilot BurnerTO TURN OFF GASTO APPLIANCEShutting Off Fireplace1. Turn control knob clockwise tothe OFF position.2. If Using Optional Hand-Held Remote:Set selector switch in the OFF position toprevent draining battery.Shutting Off Burners Only (pilot stays lit)You may shut off the burners and keep the pilotlit by doing one of the following:1. Turn control knob clockwise tothe PILOT position.2. If Using Optional Hand-Held Remote: Useremote control manual OFF button.WARNING: Make sure remotesensor selector switch is in theOFF position when you are awayfrom home for long periods oftime.MANUAL LIGHTINGPROCEDURE1. Follow steps 1 through 5 under LightingInstructions, page 24.2. Depress control knob and light pilot withmatch.3. Keep control knob pressed in for 30 secondsafter lighting pilot. After 30 seconds, releasecontrol knob. Now follow steps 8 and 9under Lighting Instructions, column 1.OPTIONAL HAND-HELDREMOTE OPERATIONNote: All remote control accessories must bepurchased separately (see Accessories, page 44).Follow instructions included with the remotecontrol.NOTICE: You must light the pilotbefore using the hand-held re-mote control unit. See LightingInstructions on page 24.After lighting, let pilot flame burn for aboutone minute. Turn control knob to ON position.Adjust flame adjustment knob anywhere be-tween HI and LO. Slide the selector switch tothe REMOTE position (see Figure 47, page 26).