3108382OWNER’S MANUALFor more information, visit www.desatech.comPRODUCT IDENTIFICATIONLOCAL CODESInstall and use heater with care. Follow alllocal codes. In the absence of local codes, usethe latest edition of The National Fuel GasCode, ANSI Z223.1/NFPA 54*.*Available from:American National Standards Institute, Inc.1430 BroadwayNew York, NY 10018National Fire Protection Association, Inc.Batterymarch ParkQuincy, MA 02269Note: Where listed vented decorative logsare required, thermostat operation is notpermitted.UNPACKINGCAUTION: Do not remove themetal data plates from the grateassembly. The data plates containimportant product information.1. Remove logs and heater base assem-bly from carton.Note: Do not pick upheater base assembly by the burner.This could damage heater. Alwayshandle base assembly by grate.2. Remove all protective packaging ap-plied to logs and heater for shipment.3. Check all items for any shipping dam-age. If damaged, promptly informdealer where you bought heater.PRODUCTFEATURESOPERATIONThis heater is clean burning. It requires nooutside venting. There is no heat loss out a ventor up a chimney. Heat is generated by realistic,dancing yellow flames. This heater is de-signed for vent-free operation with flue damperclosed. It has been tested and approved toANSI Z21.11.2 standard for unvented heaters.State and local codes in some areas prohibitthe use of vent-free heaters. This heater mayalso be operated as a vented decorative prod-uct (ANSI Z21.60) by opening flue damper(non-thermostat operation only).APPLICATIONThese multisided logs are designed to beequally beautiful when viewed from any angle.They are designed specifically for use insee-through, peninsula, and island fireboxeswith multiple openings. You may also in-stall this log heater in a standard firebox.SAFETY PILOTThis heater has a pilot with an Oxygen Deple-tion Sensing (ODS) safety shutoff system.The ODS/pilot is a required feature for vent-free room heaters. The ODS/pilot shuts offthe heater if there is not enough fresh air.PIEZO IGNITION SYSTEMThis heater has a piezo ignitor. This systemrequires no matches, batteries, or othersources to light heater.REMOTE CONTROLACCESSORIESThere are four optional remote controls thatcan be purchased separately for this log heater:• wall switch• wall thermostat• hand-held ON/OFF remote• hand-held thermostat remoteSee Accessories, page 24.NOTE: The wall thermostat or hand-heldthermostat may not be used where venteddecorative listing is required.SAFETYINFORMATIONContinued13. Do not use this heater to cook food orburn paper or other objects.14. Do not use heater if any part has beenexposed to or under water. Immediatelycall a qualified service technician to in-spect the room heater and to replace anypart of the control system and any gascontrol which has been under water.15. Do not operate heater if any log is bro-ken. Do not operate heater if a log ischipped (dime-sized or larger).16. Turn heater off and let cool before ser-vicing, installing, or repairing. Make surethe selector switch is in the OFF posi-tion. Only a qualified service personshould install, service, or repair heater.17. Make sure the selector switch is in theOFF position when you are away fromhome for long periods of time.18. This heater must not be connected toany external electrical source.19. Operating heater above elevations of4,500 feet could cause pilot outage.20. Provide adequate clearances around airopenings.AUTOONOFFCOOLERWARMERTEMP Figure 1 - Product IdentificationControl KnobPiezoIgnitorLog SetBase AssemblyOptionalRemoteControlFlameAdjustmentKnobOptionalSelectorSwitch