Desa LMFP33NR Owner's Operation And Installation Manual

Also see for LMFP33NR: OWNER'S OPERATION AND INSTALLATION MANUAL OWNER'S OPERATION AND INSTALLATION MANUAL OWNER'S OPERATION AND INSTALLATION MANUAL OWNER'S OPERATION AND INSTALLATION MANUAL OWNER'S OPERATION AND INSTALLATION MANUAL

Desa LMFP33NR Owner's Operation And Installation Manual Manual pdf 17 page image

111604-01AFor more information, visit www.desatech.comFor more information, visit www.desatech.com1717INSTALLATIONContinuedINSTALLING BATTERIES FOR REMOTERECEIVER AND HAND HELD REMOTECONTROLFour AA batteries and three AAA batteries are required to operate thisheater with the wireless hand-held remote control set. Four AAbatteries must be installed in the receiver and three AAA batteries inthe hand-held remote control unit.Note: Only use alkaline batteries.Installing Batteries in Receiver1. Locate slot on battery cover of receiver (see Figure 32). Firmlyinsert tool such as a small screwdriver, butter knife, or dimeinto the slot and lift up to remove cover.2. Insert 4 AA batterines into receiver. Positive and negative aremarked inside receiver casing.Note: Receiver will not func-tion if batteries are not installed correctly.3. Slide tab on cover into receiver housing and snap cover backinto place.Figure 33 - Installing Batteries in Remote ControlCoverRemoteControl3 AAABatteriesInstalling Battery into Remote1. Remove remote cover (see Figure 33).2. Insert 3 AAA batteries into remote control (see Figure 33). Posi-tive and negative are marked inside remote control casing.Note:Remote will not function if batteries are not installed correctly.3. Slide remote cover back into place.Figure 32 - Installing Batteries in ReceiverCoverReceiverSlot4 AABatteriesBatteryHousingBackupSwitchINSTALLATIONInstalling Batteries For Remote Receiver and Hand-Held Remote ControlOPERATING HEATERFor Your Safety Read Before LightingLighting InstructionsWARNING: If you do not follow these instructionsexactly, a fire or explosion may result causing prop-erty damage, personal injury or loss of life.A. This appliance has a pilot which must be lighted by hand.When lighting the pilot, follow these instructions exactly.B. BEFORE LIGHTING smell all around the appliance areafor gas. Be sure to smell next to the floor because some gasis heavier than air and will settle on the floor.WHAT TO DO IF YOU SMELL GAS• Do not try to light any appliance.• Do not touch any electric switch; do not use any phone inyour building.• Immediately call your gas supplier from a neighbor’sphone. Follow the gas supplier’s instructions.• If you cannot reach your gas supplier, call the fire de-partment.C. Use only your hand to push in or turn the gas control knob.Never use tools. If the knob will not push in or turn byhand, don’t try to repair it, call a qualified service techni-cian or gas supplier. Force or attempted repair may resultin a fire or explosion.D. Do not use this appliance if any part has been under water.Immediately call a qualified service technician to inspectthe appliance and to replace any part of the control systemand any gas control which has been under water.FOR YOUR SAFETYREAD BEFORE LIGHTINGLIGHTINGINSTRUCTIONSWARNING• If fireplace has glass doors, never operate thisheater with glass doors closed. If you operateheater with doors closed, heat buildup inside fire-place will cause glass to burst. Make sure there areno obstructions across opening of fireplace.• You must operate this heater with a fireplace screenin place. Make sure fireplace screen is closedbefore running heater.NOTICE: During initial operation of new heater, burn-ing logs will give off a paper-burning smell. Orangeflame will also be present. Open damper or window tovent smell. This will only last a few hours.OPERATING HEATER