Desa LMFP33NR Owner's Operation And Installation Manual

Also see for LMFP33NR: OWNER'S OPERATION AND INSTALLATION MANUAL OWNER'S OPERATION AND INSTALLATION MANUAL OWNER'S OPERATION AND INSTALLATION MANUAL OWNER'S OPERATION AND INSTALLATION MANUAL OWNER'S OPERATION AND INSTALLATION MANUAL

Desa LMFP33NR Owner's Operation And Installation Manual Manual pdf 8 page image

111604-01AFor more information, visit www.desatech.comFor more information, visit www.desatech.com8*INSTALLATIONContinuedFigure 7 - Attaching Brass Trim to FireplaceFigure 6 - Assembling Brass TrimASSEMBLING AND ATTACHING OPTIONALBRASS TRIM(Included with Mantel Accessory)IMPORTANT: If you are recessing the firebox in a wall, do notattach brass trim at this time. See page 10.Note: The instructions below show assembling and attaching brasstrim to fireplace.1. Remove packaging from three pieces of brass trim.2. Locate four brass screws, two adjusting plates with set screws,and two shims in the hardware packet.3. Align shim under adjusting plate as shown in Figure 6.4. Slide one end of adjusting plate/shim in slot on mitered edgeof top brass trim (see Figure 6).5. Slide other end of adjusting plate/shim in slot on mitered edgeof side brass trim (see Figure 6).6. While firmly holding edges of brass trim together, tighten bothset screws on the adjusting plate with slotted screwdriver.7. Repeat steps 1 through 6 for other side.8. Tighten trim hanging screws (#10 x 6.25 shoulder) into holesin cabinets. Place the assembled trim onto fireplace cabinet.Align hanging notches on trim with hanging screws on side offireplace (see Figure 7). Push trim firmly into place, slidinghanging notches over hanging screws.Side BrassTrimTopBrassTrimSlotMitered EdgeSlotShimSet ScrewsAdjustingPlateTrimHangingScrewsAssembledBrass TrimHangingNotcheson TrimINSTALLATION CLEARANCESWARNING: Maintain the minimum clearances. Ifyou can, provide greater clearances from floor, ceil-ing, and adjoining wall.Carefully follow the instructions below. This will ensure safeinstallation.Minimum Clearances For Side CombustibleMaterial, Side Wall, and CeilingA. Clearances from the side of the fireplace cabinet to any com-bustible material and wall should follow diagram in Figure 8.Example: The face of a mantel, bookshelf, etc. is made ofcombustible material and protrudes 3 1/ 2" from the wall. Thiscombustible material must be 4" from the side of the fireplaceopening (see Figure 8).B. Clearances from the top of the fireplace opening to the ceilingshould not be less than 42 inches.Figure 8 - Minimum Clearance for Combustible to Wall*Minimum 16 inches from Side WallExampleMINIMUM CLEARANCE TOCOMBUSTIBLE MATERIALSTop Left and BottomRight Sides and Rear42" 16" 0"INSTALLATIONAssembling and Attaching Optional Brass TrimInstallation Clearances