Desa M36B Owners Manual And Installation Manual

Also see for M36B: OWNER'S OPERATION AND INSTALLATION MANUAL Owner's operating and installation manual OWNER'S OPERATION AND INSTALLATION MANUAL OWNER'S OPERATION AND INSTALLATION MANUAL

Contents

Desa M36B Owners Manual And Installation Manual Manual pdf 19 page image

www.desatech.com108795-01V 19oPeratIoN1. STOP! Read the safety information, col-umn 1.2. Turn wall switch to the OFF position.3. Turn off all electric power to appliance.4. Fully open glass doors if installed.5. Remove front refractory brick accesspanel.6. Turn gas control knob clockwiseto the OFF position (see Figure 39).7. Wait five (5) minutes to clear out any gas.Then smell for gas, including near thefloor. If you smell gas, STOP! Follow “B”in the safety information, column 1. If youdon’t smell gas, go to the next step.8. Turn control knob counterclockwiseto the PILOT position.9. Push in knob all the way and hold in.Immediately light the pilot manually. Con-tinue to hold control knob in for about oneminute after pilot is lit. Release knob andit will pop back up. Pilot should remain lit.If it goes out, repeat steps 5 through 9.• If knob does not pop up when released,stop and immediately call your servicetechnician or gas supplier.• If the pilot will not stay lit after severaltries, turn the gas control knob to OFFand call your service technician or gassupplier.10. Turn gas control knob counterclockwiseto O”. Knob can be turned to ONonly if the control knob is popped out.11. Replace front refractory brick accesspanel.12. Fully close glass doors if installed.13. Turn on all electric power to appliance.PILOT ONOFFIN OUTINFigure 39 - Control Knob in the PILOTpositionPosition IndicatorGas Control Knob Pilot Adjustment ScrewFOR YOUR SAFETYREAD BEFORE LIGHTINGWARNING: If you do not fol-low these instructions exactly,a fire or explosion may resultcausing property damage, per-sonal injury or loss of life.A. This appliance has a pilot which mustbe lighted by hand. When lightingthe pilot, follow these instructionsexactly.B. BEFORE LIGHTING smell all aroundthe appliance area for gas. Be sure tosmell next to the floor because somegas is heavier than air and will settleon the floor.WHAT TO DO IF YOU SMELL GAS• Do not try to light any appliance.• Do not touch any electric switch; donot use any phone in your building.• Immediately call your gas supplierfrom a neighbor’s phone. Follow thegas supplier’s instructions.• If you cannot reach your gas supplier,call the fire department.C. Use only your hand to push in or turnthe gas control knob. Never use tools.If the knob will not push in or turn byhand, don’t try to repair it, call a quali-fied service technician or gas supplier.Force or attempted repair may result ina fire or explosion.D. Do not use this appliance if any parthas been under water. Immediatelycall a qualified service technician toinspect the appliance and to replaceany part of the control system andany gas control which has been underwater.LIGHTINGINSTRUCTIONSNOTICE: During initial operationof new heater, burning logs willgive off a paper-burning smell.Orange flame will also be pres-ent. Open damper or window tovent smell. This will only last afew hours.